Successfully reported this slideshow.
We use your LinkedIn profile and activity data to personalize ads and to show you more relevant ads. You can change your ad preferences anytime.

Woodworking designs

546 views

Published on

Woodworking designs from Marshall Middle School

Published in: Education
  • Be the first to like this

Woodworking designs

  1. 1. Middle School Woodworking Ben Kellman Marshall Middle School Billerica, MA
  2. 2. Side Table Project
  3. 3. SIDE TABLES • Side tables are made of ¾” poplar • Legs are ‘1x3’s( ¾ x 2.5”); taper is cut with bandsaw and then hand-planed • Rails are 1x4’s or 1x6’s • Top and middle shelf are edge-glued 1x6’s; top edge is finished with 3/8” roundover done with portable router • Fastening is done with countersunk 1-5/8” drywall screws, covered with wood filler • Tables are finished with polyurethane
  4. 4. Variation on table Includes 1” stripe of wenge laminated into top or pull-out drawer
  5. 5. Napkin Holder • The napkin holders use a common base of 1x3 poplar cut to 3” x 2.5” • Side pictures are drawn using templates, cut out on the bandsaw, and hand-sanded • Napkin capacity is 1.5” • Side pictures are fastened to base using countersunk 1-5/8” drywall screws
  6. 6. Merry-Go- Round • The Merry-go-round consists of a an 8” diameter carousel disk with a 5/8” diameter center hole, a 5” diameter disk with a ½” diameter center hole, and an 11” ½” diameter dowel • 4 figures ride on the merry-go-round; these could be laser-cut • The carousel disk is suspended by nylon string
  7. 7. Letters • Letters, cut out with a coping saw, are a fun project • Tops and bottoms should have a flat area for gluing together, using a ¼” dowel for added strength
  8. 8. Jewelry stand is made of a found stick attached into a 4.5” diameter disk of 1x6 poplar; brass hooks can then be added to the branches
  9. 9. Clock/Wall shelf
  10. 10. Clock Wall shelf • Shelves are made of 1x4 poplar • Top and clock face is 1x6 poplar • Shelves fastened with countersunk 1 5/8” drywall screws • Hours are marked with hardwood plugs sanded flat • Clock is battery powered quartz unit- see http://www.klockit.com/
  11. 11. Table Clock • Base and top are 1x3 poplar • Clock face is edge-glued 1x6 poplar • Hours are marked with 3/8” wood plugs sanded smooth • Quartz movement and hands from Klockit.com
  12. 12. Rocking figures • Rockers( 2) are from 1x4 poplar or pine • Figure in center is traced using template
  13. 13. Baskets • Baskets can be in all different sizes • Side strips are ¾” w x 3/16” thick, attached with brads and glue • End panels can be plain or whimsical • End panel can include a ¾” dia hole for dowel-handle
  14. 14. Figures can be made from ¾” pine notched to fit together without glue
  15. 15. Detail of deer figure
  16. 16. Paddle-Wheel Boat
  17. 17. Box with sliding top • Box is ¼” x 2.5” pine • Slot for top is 1/8”( cut on table saw)
  18. 18. Spoon • Spoon is mahogany, with blank 1.5” x 3.5” • Bowl cut with gouge, then rest on bandsaw

×