Pregnancy test in cow

17,411 views

Published on

Cattle pregnancy test for rapid early detection of pregnancy in cow

ubio quickVET pregnancy detection test provides a perfect tool to detect non-pregnancy in cattle accurately within 21 days. The kit provides 100 percent detection of non-pregnant cases and allows insemination at the first opportunity. The test can be easily performed within 20 minutes at cow-side without any instrumentation, which makes the tool attractive even for direct use by dairy farmersCattle pregnancy test for rapid early detection of pregnancy in cow

ubio quickVET pregnancy detection test provides a perfect tool to detect non-pregnancy in cattle accurately within 21 days. The kit provides 100 percent detection of non-pregnant cases and allows insemination at the first opportunity. The test can be easily performed within 20 minutes at cow-side without any instrumentation, which makes the tool attractive even for direct use by dairy farmers

Published in: Health & Medicine, Technology
0 Comments
16 Likes
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total views
17,411
On SlideShare
0
From Embeds
0
Number of Embeds
20
Actions
Shares
0
Downloads
444
Comments
0
Likes
16
Embeds 0
No embeds

No notes for slide

Pregnancy test in cow

  1. 1. Pregnancy Diagnosis in Cow
  2. 2. Accurate diagnosis of pregnancy is of crucial importance in maintaining optimal reproductive performance of cattle and high profitability of dairy farms. It is most beneficial if non-pregnancy can be detected before the first heat after insemination. Conventional methods that allow early detection of pregnancy are not accurate enough, and reliance on these methods results in a large number of non-pregnant cows assumed to be pregnant and some pregnant cows being inseminated inappropriately, which could abort them. Conventional pregnancy detection methods that are accurate, on the other hand, can be performed only after at least 35 days after insemination, leading to the loss of at least one opportunity to inseminate Introduction
  3. 3. ubio’s quickVET pregnancy detection test <ul><li>Detect non-pregnancy in cattle accurately within 21 days. </li></ul><ul><li>100% detection of non-pregnant cases and allows insemination at the first opportunity. </li></ul><ul><li>The average savings realized through the use of ubio quickVET test is as high as Rs.1300/- per cow per lactation period. </li></ul><ul><li>The test can be easily performed within 20 minutes </li></ul><ul><li>Cow-side test without any instrumentation, which makes the tool attractive even for direct use by dairy farmers. </li></ul><ul><li>It measures progesterone levels in milk or serum (for heifers) using a Rapid ELISA technique. </li></ul>
  4. 4. COMPARISON OF PREGNANCY DETECTION TECHNIQUES
  5. 5. ASSAY PRINCIPLES <ul><li>The ubio quickVET pregnancy test is based on ELISA-based progesterone assay principle. </li></ul><ul><li>The test measures progesterone concentration in milk or blood using Rapid ELISA technique. </li></ul><ul><li>If the sample contains progesterone (animal is pregnant), the test card will be completely white. If the progesterone level is very low (non-pregnant animal), a bright blue colour will appear on the card. </li></ul>
  6. 6. <ul><li>The concentration of progesterone in the milk or blood of a non-pregnant cow varies as shown. with Day 0 corresponding to the occurrence of heat. It is assumed that insemination is appropriately performed at the time of heat </li></ul><ul><li>In the case of a pregnant cow, the progesterone concentration varies as shown. </li></ul>
  7. 7. Test Procedure
  8. 8. Kit components <ul><li>One Aluminium pouch containing the test cassette. </li></ul><ul><li>Three droppers for transferring milk and reagents. </li></ul><ul><li>One transparent vial marked ‘1’ containing reagent 1. </li></ul><ul><li>One dropper bottle marked ‘2’ containing wash buffer (reagent 2). </li></ul><ul><li>One opaque vial marked ‘3’ containing reagent 3 </li></ul>
  9. 9. <ul><li>Collect milk sample from cow in a clean vessel after discarding milk from the first few pulls. </li></ul><ul><li>For pregnancy test, the test should be done between 19 th to 23 rd day after insemination.. </li></ul>
  10. 10. <ul><li>Keep the test pack at 26-30ºC for 1-2 hours to bring it to room temperature. </li></ul><ul><li>Remove the test cassette from pouch and keep on a flat surface. </li></ul><ul><li>There are two wells on the card, marked C and T. </li></ul>
  11. 11. <ul><li>Add three (3) drops of milk to the test well (marked T) using a dropper supplied with the test. </li></ul><ul><ul><ul><ul><li>Dispose the dropper immediately. </li></ul></ul></ul></ul><ul><li>Add one (1) drop of Reagent 2 to the control well (marked C). </li></ul>
  12. 12. <ul><li>Using a fresh dropper, Add three (3) drops into both the wells (C and T) from the bottle marked Reagent 1. Let milk and reagent mix by gently tapping the cassette. Take care not to splash the liquid in the wells. </li></ul><ul><li>Keep the cassette on a flat surface for 20 minutes. Gently tap the cassette at 4-minute intervals. </li></ul>
  13. 13. <ul><li>Tip the cassette and empty the wells into a sink. </li></ul><ul><li>Fill both the wells (C and T) with the wash buffer in the bottle marked ‘Reagent 2’ , tap gently and empty the wells into the sink. Repeat this washing 5-6 times. Shake off any remaining solution from the wells. </li></ul>
  14. 14. <ul><li>Add 5 drops of Reagent 3 in the opaque vial to both the empty wells (C and T). </li></ul><ul><li>Keep the test on a flat surface. </li></ul><ul><li>The result appears in 10 minutes, and can be read till 15 minutes. </li></ul><ul><li>DO NOT READ THE RESULT AFTER 15 MINUTES. </li></ul>
  15. 15. Result
  16. 16. Pregnant Test well (T) same as or lighter than control well (C)‏ Not Pregnant Test well (T) bluer than control well (C)‏
  17. 17. <ul><li>This principle provides 100% accurate results for progesterone levels, which translates to 100% accuracy for non-pregnancy. </li></ul><ul><li>However, there are some corner cases where a false positive may occur </li></ul><ul><li>for cases marked ‘pregnant’ by the test. </li></ul><ul><li>They are............................. </li></ul>
  18. 18. If heat is incorrectly interpreted, and insemination is done at the wrong time, the test will show the result as ‘pregnant’ as we are actually detecting the high progesterone level during mid-heat, instead of that caused by pregnancy. A cow that is correctly judged pregnant might lose her conceptus due to various reasons. In this case, the test is accurate, but the pregnancy does not result in calf-birth. It is suggested that the test be repeated if any sign of heat is seen after the cow is judged pregnant A cow with luteinized cystic follicles will produce progesterone at varying levels, and the test result is not reliable in such animals as it might show positive or negative based on the progesterone level on the day of test.
  19. 19. Clinical aplications <ul><li>Ovulation Test </li></ul><ul><ul><ul><ul><ul><li>ubio quickVET rapid pregnancy test for cattle can be used for detecting ovulation in cows that do not show regular symptoms of heat. </li></ul></ul></ul></ul></ul><ul><ul><ul><ul><ul><li>The test should be performed during the suspected heat period. </li></ul></ul></ul></ul></ul><ul><ul><ul><ul><ul><li>A bright blue well indicates heat and insemination can be performed in 6-18 hours. </li></ul></ul></ul></ul></ul><ul><ul><ul><ul><ul><li>A clear white well indicates mid-heat and the test needs to be repeated only after 10 days. </li></ul></ul></ul></ul></ul><ul><ul><ul><ul><ul><li>A light blue color indicates approaching or past heat, and a repeated test after 2 days will confirm the condition. </li></ul></ul></ul></ul></ul>
  20. 20. <ul><li>Identification of follicular/luteal cysts: </li></ul><ul><ul><ul><li>Cystic cows having a low progesterone concentration are considered to have follicular cysts, and those with high concentrations are classified as having luteal cysts. </li></ul></ul></ul><ul><ul><ul><li>For practical purposes, differential diagnosis of ovarian cysts is important in selection of endocrine therapy. </li></ul></ul></ul><ul><ul><ul><li>The cyst can be differentiated by performing the test on two samples taken 7 days apart – a bright blue well in both tests indicate a follicular cyst and a clear white card in both tests indicate a luteal cyst. </li></ul></ul></ul>Follicular Cyst Luteal Cyst Day 1 Day 7 Day 1 Day 7
  21. 21. <ul><li>To evaluate treatment of follicular cysts using GnRH, </li></ul><ul><ul><ul><li>ubio quickVET rapid pregnancy test can be used to evaluate to progesterone levels 10 days after administration of GnRH. A light blue spot or a clear white card indicates response to treatment. </li></ul></ul></ul><ul><li>Evaluate response to treatment of luteal cysts using Prostaglandin </li></ul><ul><ul><li>Milk progesterone testing prior to and 3 days after administration of prostaglandin can accurately assess if administration is justified (high concentration prior to administration) and if luteolysis has occurred (low concentration on day 3). </li></ul></ul>Day 0 Day 3
  22. 22. <ul><li>Evaluation of fitment for embryo transfer: </li></ul><ul><ul><ul><li>ubio quickVET rapid pregnancy test for cattle can be used in embryo transfer programs to check if there is adequate progesterone level in the recipient to support the embryo. </li></ul></ul></ul><ul><ul><ul><li>The recipient should show a light blue test result before an embryo is transferred. </li></ul></ul></ul>
  23. 23. For further details and placing orders ubio Biotechnology Systems Pvt Ltd. XII/111-E/F, Biotechnology Incubation Center Kinfra Hi-Tech Park, Kalamassery Cochin, India 683503 Ph: +91-484-2532966, +91-9446438678, +91-9744122269 Email: [email_address] www.ubio.in
  24. 24. www.ubio.in [email_address]

×