Upcoming SlideShare
×

# Ch 5 problems

26,815 views

Published on

Published in: Education
• Full Name
Comment goes here.

Are you sure you want to Yes No
• useful

Are you sure you want to  Yes  No

### Ch 5 problems

1. 1. Solved ExamplesProblem 5.6: for the beam and loading shown, (a) draw the shear andbending-moment diagrams, (b) determine the equations of the shear andbending-moment curves.Solution:Drawing the free body diagram and applying equilibrium are shown in thefollowing figure: ……(1)
2. 2. ∫Now, we want to get values of shear and bending moment at :Substitute in (1) &(2) &(3) we find that :
3. 3. It is clear that moment at x=0 ,x=L is zero as there is not concentrated M.
4. 4. Problem 5.11: Draw the shear and bending-moment diagrams for thebeam and loading shown, and determine the maximum absolute value (a) ofthe shear, (b) of the bending moment.Solution:Free body diagram:∑ ∑ ∑
5. 5. There is a jump in bending moment at D(x=0.3 m)There is a jump in bending moment at F (x=0.9 m)
6. 6. Now we can draw the S.F.D and the B.M.D:| | | |
7. 7. Problem 5.55: Draw the shear and bending-moment diagrams for thebeam and loading shown, and determine the maximum normal stress due tobending.Solution:Free body diagram: ∑ ∑ ∫ ∫ ∫
8. 8. ∫Now, we want the values of S,M at A,C,B:
9. 9. Now we can draw the S.F.D and the B.M.D:Note: This diagram is not to scale.
10. 10. Problem 5.67: For the beam and loading shown, design the cross section ofthe beam. Knowing that the grade of timber used has an allowable stress of12 MPa. Fig. P5.67Solution:Free body diagram:∑ ∑Shear & bending moment diagrams:
11. 11. From B.M.D, We can see obviously thatProblem 5.79: A steel pipe of 100 mm diameter is to support the loadingshown. Knowing that the stock of the pipes available has thickness varyingfrom 6 mm to 24 mm in 3-mm increments, and that the allowable normalstress for the steel used is 165 MPa, determine the minimum wallthicknesses t that can be used. Fig. P5.79
12. 12. Solution:Shear & bending moment diagrams:From B.M.D, We can see obviously that , the min. wall thickness that can be used is t=9 mm.
13. 13. Problem 5.91: A 240-KN load is to be supported at the center of the 5-m spanshown. Knowing that the allowable normal stress for the steel used is 165MPa, determine the smallest allowable length of beam if the beam AB is not to be oversterssed, the most economicalshape that can be used for beam . Neglect the weight of both beams.Solution:For the beam ( ) ( )Substituting in (1), we have :Shear & bending moment diagrams:
14. 14. [ ]
15. 15. ( ) (Reqired no. 1)For Beam AB: