Model dwl 200 series digital torpedo level

569 views

Published on

Published in: Self Improvement
  • Be the first to comment

  • Be the first to like this

Model dwl 200 series digital torpedo level

  1. 1. Model DWL 200 SeriesThe DWL 200 is a 200 mm length Digital Mini Level. The strong impact resistance ABSplastic material is molded with a tough Aluminium base to form the rugged yet elegantbody structure.Models: Models Special Feature DWL 200 Resolution 0.1° DWL 280 Resolution 0.05°~ 0.1° Dimension L(200) x H(42.5) x T(18) mmFeatures & Specification: Application: Displayed in Degrees (° or slope (%) )• Measurement Range 0° ~ +/- 90° High Resolution 0.05°~ 0.1°• Operating Temperature 0° ~ 50° C• Long Battery Life with 3 minutes auto off• Easy, Clear & Precise Digital Display• Hold Function to Freeze Display• Buzzer Sound with Build-in Vials With magnet on the base Power supply 2 x 3v Lithium cell (Batteries included) For further information, please refer to www.digipas.co.uk
  2. 2. CALIBRATION INSTRUCTION OPERATIONCaution: Digi-Pas is calibrated in the Factory for a) Batteries:maximum accuracy. User only recalibrate unless  Open the battery compartment at thenecessary. rare of the Digi-Pas .  Remove the small plastic from two new1. Push ONCE on the Cal button then batteries (type AAA/LR03).release.Buzzer starts to beep.  Ensure correct polarity.2a. Place Digi-Pas on a flat surface (e.g. Table) b) Switching on the Digi-Pas:Use a finger to Press Mode button ONCE while  Switch the Digi-Pas on using the on/offwait a few seconds until buzzer beeps. switch. b. Place Digi-Pas reverse horizontal (180° Press )  The Digi-Pas can measure angles rangeMode button ONCE and wait a few seconds until 0°~ +/- 90°buzzer beeps.  press mode button to choose the c. Place Digi-Pas vertically (-90° and Press ) resolution in degree or slope angle (IfMode button ONCE and wait a few seconds until slopes are measured)buzzer beeps. c) Buzzer Sound (Acoustic signal): d. Place Digi-Pas reverse vertically (+90° and )  The Buzzer Sound are used to indicatedPress Mode button ONCE and wait a few seconds angle of slope stands at 0° 45° 90° , , .until buzzer beeps.  To switch off Acoustic signal, hold the3. Calibration completes when buzzer beep Mode for more than 2 seconds, thesound stops. speaker enunciator will be disappeared. NOTE : Ensure Digi-pas is kept still duringCalibration d) Magnets on the based  The Digi-Pas can be affixed to any magnetic surface. e) Hold button (Memory functions)  With the hold button, you can Freeze Display for reading and the current measurement result can be saved in the internal memory.  Return to normal measuring mode by pressing Hold button  To call back the reading in the internal memory, press Hold button for 3 second. The previous save reading will be appearing in the display. f) Switching off:  To switch off the Digi-Pas, press the on/off switch .When not in use more than 3 min, the Digi-Pas will switches off automatically. UK and Europe sales office Tarax Technology Limited First Floor, Office 2, 10 Panmure Street, Dundee, DD1 2BW. e:Info@digipas.co.uk w:www.digipas.co.uk m:(+44)07825041403 For further information, please refer to www.digipas.co.uk

×