Successfully reported this slideshow.
Your SlideShare is downloading. ×

DOC-20221125-WA0003..pdf

Ad
Ad
Ad
Ad
Ad
Ad
Ad
Ad
Ad
Ad
Ad
Upcoming SlideShare
pavement design_090120.pdf
pavement design_090120.pdf
Loading in …3
×

Check these out next

1 of 29 Ad

More Related Content

Advertisement

DOC-20221125-WA0003..pdf

  1. 1. REINFORCED CONCRETE Introduction Reinforced concrete is a composite material, consisting of steel reinforcing bars embedded in concrete. Concrete has high compressive strength but low tensile strength. Steel bars can resist high tensile stresses but will buckle when subjected to high tensile stresses but will buckle when subjected to comparatively low compressive stresses. Steel bars are used in the zones within a concrete member which will be subjected to tensile stresses. Reinforced concrete is an economical structural material which is both strong in compression and in tension. Concrete provides corrosion protection and fire resistance to the steel bars.
  2. 2. During the course of this Training, we will be looking at the following :  Limit State Design  Limit State Design  Design of Reinforced Concrete Beam  Design of Reinforced Concrete Slab  Design of Reinforced Concrete Column
  3. 3. This Course is designed to enhance participants knowledge of structural design of reinforced concrete structures in line with applicable code of practise. Learning Objectives
  4. 4. At the End of this Course, Participants should be able :  Estimate the load on any given structural member. Learning Outcomes  Analyse the member for shear force and bending moments.  Design for shear and moment reinforcements.  Carry out serviceability checks.
  5. 5. DESIGN OF REINFORCED CONCRETE SLAB DESIGN OF REINFORCED CONCRETE SLAB
  6. 6. Learning Outcome At the End of this Module, you should be able : • Design reinforced concrete slab.
  7. 7. DESIGN OF RC SLAB
  8. 8. SLAB DESIGN 1.
  9. 9. SLAB DESIGN 1.
  10. 10. SLAB DESIGN 1.
  11. 11. SLAB DESIGN 1.
  12. 12. SLAB DESIGN 1.
  13. 13. SLAB DESIGN 1.
  14. 14. SLAB DESIGN 1.
  15. 15. SLAB DESIGN 1.
  16. 16. SLAB DESIGN 1.
  17. 17. SLAB DESIGN 1.
  18. 18. WORKED EXAMPLES
  19. 19. DESIGN OF ONE WAY SLAB 1. Design the water tank slab over the stair hall of a residential building shown below using 20 – 250 concrete.
  20. 20. DESIGN OF ONE WAY SLAB 1.
  21. 21. DESIGN OF ONE WAY SLAB 1.
  22. 22. DESIGN OF TWO WAY SLAB 1.
  23. 23. DESIGN OF TWO WAY SLAB 1.
  24. 24. DESIGN OF TWO WAY SLAB 1.
  25. 25. Hope Everything is Clear so far? Clear so far?
  26. 26. Thank you for Your TIME Your TIME

×