2. Automatic wire cutting and stripping machine
EcoStrip 9300
EcoStrip 9300 with the TU1 twisting unit
High performance at a low price
EcoStrip 9300 – cost-effective- The EcoStrip 9300 automatic wire
cutting and stripping machine was intro-
ness, flexibility, versatility and duced with economic efficiency as the
top priority for the user. Wide application
quality guarantee high-level cus- range, high productivity, simple opera-
tion and the well-known Schleuniger
tomer benefits. stripping quality are the main features of
this machine. The EcoStrip 9300 also
proves that good technology does not
have to be expensive.
3. TU 1 twisting unit Parallel processing Specific product
advantages
s Quick programming (complete
wire library with default values
in mm2 and AWG)
s Simple operation as of LED-
programming guide and display
s Automatic wire load and unload
s Quick change guides
s Integrated wire jam detector
and out-of-wire sensor
Using the optional TU 1 twisting unit, Special guides and cutting blades allow
stranded wire can be twisted after being simultaneous processing of two or four s Wire list processing
stripped. The twisting direction and wires. The production throughput of the
intensity are programmable. One can machine is thus significantly increased. s Special cable processing
also select between full and partial strip- (e.g. flat ribbon cable)
ping. The inaccuracy of length resulting
from the twisting procedure can be s Automatic twisting unit (option)
corrected through subsequent cutting.
The TU 1 twisting unit can also be used s PC-remote control capability
for parallel processing of two wires.
s Interfaces for various pre- and
post-processing accessories
Flat ribbon cable
Short mode unit processing
The optional short mode belt type unit, A set of special guides enables process-
which can grasp the cable very close to ing of flat ribbon cables.
the cutting blades, is recommended for
processing of very short wires (remaining
insulation shorter than 45 mm).
PC-remote control Processing examples
The serial RS 232 interface (option) is Cutting to length
offered for complete remote control of
the machine. For this purpose, all
processing parameters are loaded into Stripping with partial and / or
the machine as an ASCII file from a PC. full pull-off
Processing is subsequently started or Window stripping
interrupted via a command. Error condi-
tions and status information are reported Jacket stripping of flat ribbon cables
back to the PC. A demo disk containing and multi-conductor cables
both a terminal program under Windows Stripping of extremely short wires
3.1/95 and several data examples is
available.
Stripping and twisting of stranded wire