Die Casting

8,044 views

Published on

Presentation

Published in: Education, Business, Technology
0 Comments
8 Likes
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total views
8,044
On SlideShare
0
From Embeds
0
Number of Embeds
245
Actions
Shares
0
Downloads
350
Comments
0
Likes
8
Embeds 0
No embeds

No notes for slide

Die Casting

  1. 1. Die Casting
  2. 2. Gravity Die Casting
  3. 3. Gravity die casting process Mazak, an alloy of Zinc and aluminium, is first melted in a crucible furnace. Molten metal is then poured by ladle in to an open steel mould where it is allowed to cool and solidify.
  4. 4. Gravity die casting process The mould is then turned upside down and tapped with a hammer to release the finished casting. Gravity die casting requires minimal finishing and waste as minimal because excess metal can be melted down and used again.
  5. 5. Things that you may recognise Things that are made from gravity die casting are: Toaster - Lawnmowers - Car wheel rims -
  6. 6. Identifying the process When something has been created by gravity pressure die casting there would be: Section hair lines ejector pin marks sprue and runner marks
  7. 7. Materials The materials used in gravity die casting is a mixture of Zinc and aluminium. Zinc - Aluminium -
  8. 8. High pressure die casting
  9. 9. High Pressure Die Casting Forcing metal under high pressure to form a mould. These moulds are called dies and are made from steel. This produces non-ferrous metals.
  10. 10. Materials used Metals that are commonly used are also: Aluminium - Zinc -
  11. 11. What is made from the process In this process you can make: Golf club heads - Car engine blocks - Radiators -
  12. 12. High pressure die casting process First the mould is sprayed with lubricant and closed. Molten metal is then injected into the mould under high pressure.
  13. 13. High pressure die casting process Once the cavity is filled, the pressure is kept at a steady level until the casting has become solid. Finally, the die is opened and the casting is injected.
  14. 14. Identifying the process When something has been created dy high pressure die casting there would also be: Section hair lines ejector pin marks sprue and runner marks

×