PermaClean 100


Published on

With Induron's PermaClean 100, you can coat you tank and forget it.

Published in: Technology
  • Be the first to comment

  • Be the first to like this

No Downloads
Total views
On SlideShare
From Embeds
Number of Embeds
Embeds 0
No embeds

No notes for slide

PermaClean 100

  1. 1. PERFORMACE TESTING TEST M E T HO D DUR ATION RESULT Impact Resistance ASMT D-2794 7 days 80 inch-pounds Recoat - 140°F, Elcometer ASTM D-4561 24 hours OK Adhesion, X-Cut ASTM D-3359 7 days 5A 5% Salt Water @ 120°F Immersion 10,500 hours No Effect 120°F Water Immersion ASTM D-714 24,000 hours No Effect 120°F 25% NaOH ASTM D-714 24,000 hours No Effect Salt Spray 5% NaCl ASTM B-117 Non-scribed 24,000 hours No Effect Scribed 10,500 hours 6 Rating Induron Coatings Inc. 3333 Richard Arrington Jr. Blvd N Birmingham, Alabama 35234-2303 Phone: 205-324-9584 · 800-324-9584 · Fax: 205-320-5220 · Email: Coat it and Forget it. PermaClean 100
  2. 2. INDURON PROTECTIVE COATINGS PERMACLEAN 100 COAT IT AND FORGET IT. A field inspected project using Induron’s PermaClean 100 provides these advantages: I Verification of specified surface cleanliness and anchor profile I Solvent free system eliminates VOC’s, HAP’s and the possibility of solvent entrapment With Induron’s Ceramic Epoxies we’re ready to “Put our money where our mouth is” with an unprecedented 15 year warranty for immersion service in water tanks. How is this possible you ask? Because we have over 30 years of experience with ceramic epoxies in water tanks, sanitary sewage and other immersion exposures with no documented failures on substrates that have been abrasive blasted with grit. All of our ceramic epoxies use the same proprietary technology that’s coated literally thousands of miles of sanitary sewage pipe and hundreds of water tanks. To offer this 15 year warranty we have to eliminate as many variables as possible that can affect the service life of the coating system. Most of the variables can be eliminated by proper inspection of field surface preparation and painting. Some of the variables are: I Peened surfaces I Oils, greases, mud and other contaminants on the surface from fabrication, transportation and job site staging prior to coating I Carbon deposits left from blasting with steel abrasive I Prime coats becoming hardened and chalked due to extended exposure to UV I Solvent entrapment caused by high film build, cold weather &/or poor ventilation I Unrivaled film build minimizes the risk of holidays(pinholes) and improves edge protection with up to 50 mils in a single coat. I Absolute minimal undercutting - Where pinholes occur, the corrosion cell is limited and the surrounding substrate is protected. I Coatings applied immediately after surface preparation I No chance for intercoat delamination I Can be returned to service in 72 hours. I A-Rated for cathodic disbondment. I Ultra-Low Permeability keeps water away from your substrate. PermaClean Application PermaClean 100 has a metric perm rating well under 1.0. Induron ceramic epoxies have performed well over the last 30 years, that’s why we’re willing to warrant our ceramic epoxies for up to 15 years. We know from experience they’re going to last longer than that. If you’re ready to put a coating system inside and out on your tank that will last so long we’ll have to remind you that you specified it, give your local Induron representative a call.