Successfully reported this slideshow.
We use your LinkedIn profile and activity data to personalize ads and to show you more relevant ads. You can change your ad preferences anytime.

Orcco K68 Test report(1)

  • Be the first to comment

  • Be the first to like this

Orcco K68 Test report(1)

  1. 1. 測試單位:佛山市讴歌家具有限公司測試中心 Fo Shan Rocco Furniture Co., Ltd. Product Testing Center 地址:佛山市南海区九江镇沙咀工业区园南二路园区三街 add.:No.3st,2rd,Shazui industrial park,jiujiang town,Nanhai district,Foshan City, CHINA Test Report 报告编号: 141113 Report No. 报告日期: Report Date: 2014-11-13 To: 审核批准: Approval Signatory: 伍贵书 ************************************************************************
  2. 2. - 测试目的: Sample Test Test Purpose: 产品型号: OC-K68 Model No. 样品描述: Sample Description: OK! 供应商 : ORCCO Supplier: 订单号: PO No. N/A 测试开始日期: Test Start Date: 2014-11-10 测试完成日期: Test Completed Date: 2014-11-13 测试标准: ANSI/BIFMA X5.1-2011 Test Standard: Test Summary: Section No. Description Sample #1 BIFMA X5,12011 Picture#1
  3. 3. - 1 Backrest Strength Test-Static – (UNLOCK ED) Pass 1 minute with 200ib,1 minute with 300ib. 2 Base Test -Static PASS 1 minute with 2500ib,1 minute with 2500ib.
  4. 4. - 3 Drop Test -Dynamic PASS 6inch drop 1)225ib drop at highest &lowest seat position 2) 300ib drop at highest &lowest seat position 4 Stability Tests PASS Load the chair with 13 disks (See Appendix B). Place the first disk on the seat so it touches the support fixture. As each disk is added to the stack slide it along the lower disk until it contacts the support fixture as shown in Figure 12b. As each disk is added, the backrest may move such that the lower disks do not remain against the support fixture; this is acceptable, do not reposition the disks. If the chair does not tip over and the tilt mechanism does not tilt to its most rearward position (i.e., at its tilt stop) when the disks are placed in the chair, the chair shall also be tested according to 12.3.1 with the chair in the unlocked position
  5. 5. - 5 Stability Tests- FRONT Sec 12.4 PASS Apply a vertical load of 600 N (135 lbf.), by means of the front stability loading fixture shown in Figure 12g at a point 60 mm (2.4 in.) from the front center edge of the loadbearing surface of the chair. 6 Arm Strength Test- Horizontal - Static PASS 1 minute with 100ib,1 minute with 150ib.
  6. 6. - 7 Arm Strength Test- Vertical- Static PASS 1 minute with 169ib,1 minute with 253ib. / Compressio n Test
  7. 7. - Notice: Disposition of Testing Product: The Test Lab will keep these samples for one week after testing, and then the samples will be disposed without further notice. The test report cannot be copied except in full and the test results apply only to item(s) tested. *************************** End of Report *******************************

×