The document discusses 3D scanning and printing. It describes the process of 3D printing an object in two stages - first designing the object using a program, then simulating it before printing. As a demonstration project, the author 3D printed a headphone hook. The rendering and printed object are shown. The document also mentions 3D scanning and notes the 3D printing simulation program Repetier is easy to use but has some margin of error in estimated print time.

1. 3D Scanning and Printing
Week 5

2. 3D printing

3. STAGE ONE : to design a object
3D Printing
For the 3-D printing assignment I printed a hook for my
headphones, this my first demonstration project. The
rendering and a picture of the piece are provided below and
the process of the printing.

6. STAGE TWO : to simulate in a program
3D Printing
There are many programs to simulate a 3D object before
being taken to 3D printing in this case got realize the
Repetier program is very user friendly and easy to use, their
roles are clear, but has a margin of error in the time print.

20. 3D scanning

25. Fab Academy 2014
Vaneza Caycho