EXPERIMENT NO 4

You have just been asked to build a lab network to test new configurations that will
be rolled out to you...
10:15:54 %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed
state to up

Router(config-if)#exit
Router(con...
OUTPUT AT VISUALIZER
Upcoming SlideShare
Loading in...5
×

Acn Experiment No 4

612

Published on

Acn Exp 4

Published in: Technology, Business
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total Views
612
On Slideshare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
Downloads
5
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Transcript of "Acn Experiment No 4"

  1. 1. EXPERIMENT NO 4 You have just been asked to build a lab network to test new configurations that will be rolled out to your production networks. Host A on left should be setup with ip of 192.168.101.2/24 and a default gateway of 192.168.101.1/24 Host B on right should be setup with ip of 192.168.100.2/24 and a default gateway of 192.168.100.1/24 R1(Router) Ethernet Interface 192.168.101.1/24 Serial interface 192.168.1.1/24 R2(Router) Ethernet Interface 192.168.100.1/24 Serial interface 192.168.1.2/24 We have DCE cable connected at R1 with speed of 64K R1 Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z Router(config)#interface s0/0 Router(config-if)#ip address 192.168.1.1 255.255.255.0 Router(config-if)#clock rate 64000 Router(config-if)#no shutdown 10:15:54 %LINK-3-UPDOWN: Interface Serial0/0, changed state to up 10:15:54 %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up Router(config-if)#exit Router(config)#interface f0/0 Router(config-if)#ip address 192.168.101.1 255.255.255.0 Router(config-if)#no shutdown 10:17:09 %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up 10:17:09 %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config-if)#exit R2 Router>enable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z Router(config)#interface s0/0 Router(config-if)#ip address 192.168.1.2 255.255.255.0 Router(config-if)#no shutdown 10:15:54 %LINK-3-UPDOWN: Interface Serial0/0, changed state to up
  2. 2. 10:15:54 %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up Router(config-if)#exit Router(config)#interface f0/0 Router(config-if)#ip address 192.168.100.1 255.255.255.0 Router(config-if)#no shutdown 10:17:09 %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up 10:17:09 %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up Router(config-if)#exit
  3. 3. OUTPUT AT VISUALIZER

×