1. EXPERIMENT NO 3
Using Basic Commands of network simulation
When we double click a router a console appear. On pressing enter we enable the USER
prompt. Now we write command ENABLE and press enter to enter ENABLE prompt.
In User mode all files are available but editing of these files is not possible.
#show version : This command gives which version of OS ,memory,RAM,etc
#configure terminal : For opening configuration mode.
(config)# interface S0/0/0 : Is used for configuring any interface. We can configure
serial interface as well as fast Ethernet interface using the command.
(config-if)# ip address <ipaddr> <subnet mask> : Is used to assign ip address and
subnet mask to the interface
(config-if)# no shutdown : to make network up as by default it is down.
(config-if)# exit : To exit and configure another interface