Group No. 2 : Mohd Shafwan              Aqil Fikry              Nurul Jannah              Farzana Afiqah
Contents:• Int roduc t i on• P nc i pl e of   ri  Operat i on• Advant ages• D s advant ages   i
Introduction• Plasma arc cutting is a process that is used to cut steel  and other metals of different thicknesses using p...
Principle of Operation• The plasma is tied up by a water-cooled nozzle because of the high  temperature, the plasma expand...
ADVANTAGES• Low cost alternative to oxy-fuel and laser profiling.• More versatile and accurate option.• Rapid cutting spee...
DISADVANTAGES• High equipment expense.• Need more operator skills.• Complex welding procedures.• Producing heavy noise lev...
DISADVANTAGES• High equipment expense.• Need more operator skills.• Complex welding procedures.• Producing heavy noise lev...
Upcoming SlideShare
Loading in...5
×

Workshop

207

Published on

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total Views
207
On Slideshare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
Downloads
1
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Transcript of "Workshop"

  1. 1. Group No. 2 : Mohd Shafwan Aqil Fikry Nurul Jannah Farzana Afiqah
  2. 2. Contents:• Int roduc t i on• P nc i pl e of ri Operat i on• Advant ages• D s advant ages i
  3. 3. Introduction• Plasma arc cutting is a process that is used to cut steel and other metals of different thicknesses using plasma torch.• In this process, an inert gas (compressed air) is blown at high speed out of a nozzle; at the same time an electrical arc is formed through that gas from the nozzle to the surface being cut, turning some of that gas to plasma.• The plasma is sufficiently hot to melt the metal being cut and moves sufficiently fast to blow molten metal away from the cut.
  4. 4. Principle of Operation• The plasma is tied up by a water-cooled nozzle because of the high temperature, the plasma expands and flows with supersonic velocity speed to the workpiece.• Inside the plasma arc, temperature of 30000 ᵒC can arise, that realize in connection with the high kinetic energy of the plasma beam and depending on the material thickness very high cutting speeds on all electrically conductive materials.• In this process, the stability of arc is needed to keep the plasma in desired form.• For cutting process, first of all a pilot arc ignition by high voltage between nozzle and cathode takes place.• This low-energy pilot arc prepares by ionization in parts the way between plasma arc are touches the workpiece (flying cutting, flying piercing),the main arc will start by an automatic increase in power.
  5. 5. ADVANTAGES• Low cost alternative to oxy-fuel and laser profiling.• More versatile and accurate option.• Rapid cutting speed.• Wide range of material and thickness – can yield quality cuts on both ferrous and non-ferrous metals.• Easy to use – only require minimal operator training.• Economical than oxy-fuel for thickness under 25mm and comparable up to about 50mm.
  6. 6. DISADVANTAGES• High equipment expense.• Need more operator skills.• Complex welding procedures.• Producing heavy noise level.• Producing higher ozone production.
  7. 7. DISADVANTAGES• High equipment expense.• Need more operator skills.• Complex welding procedures.• Producing heavy noise level.• Producing higher ozone production.
  1. Gostou de algum slide específico?

    Recortar slides é uma maneira fácil de colecionar informações para acessar mais tarde.

×