How to Refill the SamsungML-2010d3 toner cartridge?                The toner refill                process needs:         ...
The refill process:1. Do the toner refill process in well-lighted and ventilated room.2. If possible do the refill on a st...
6. Clean the toner chamber thoroughly. If possible use an approved vacuum   cleaner to suck contaminants out of the toner ...
13.      Pull out the used reset fuse from the cavity and insert the new fuse      that comes with the kit.   14.       Th...
Upcoming SlideShare
Loading in...5
×

How to refill the samsung ml 2010d3 toner cartridge

1,577

Published on

Published in: Technology, Business
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total Views
1,577
On Slideshare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
11
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

How to refill the samsung ml 2010d3 toner cartridge

  1. 1. How to Refill the SamsungML-2010d3 toner cartridge? The toner refill process needs:  An empty but serviceable Samsung ML2010d3 toner cartridge  A small flathead screwdriver  A compatible toner refill kit
  2. 2. The refill process:1. Do the toner refill process in well-lighted and ventilated room.2. If possible do the refill on a sturdy, flat level surface. Keep a plastic lined trashcan nearby.3. Place the empty Samsung ML2010 series toner cartridge. Loosen the two sets of screws on the side of the cartridge. Use the flathead screwdriver to uncover the large plastic seal of the toner chamber.4. Again use the small flathead screwdriver to pry open the plastic seal. Take extra caution and avoid damaging the plastic cover.5. Once the fill hole is open, hold the cartridge with the fill hole directly over the trashcan. And discard whatever is left of the old toner.
  3. 3. 6. Clean the toner chamber thoroughly. If possible use an approved vacuum cleaner to suck contaminants out of the toner chamber. Take note that contaminants must not mix with new replacement toner, print defect can actually result.7. Take out the bottle of replacement toner from the Samsung ML-2010 toner refill kit. Hold it upside down and tap it over the flat surface to loosen clumped toner. This will allow toner to flow freely.8. Open the replacement bottle cap and pull out the seal. Attach the funnel cap securely on the rim.9. Hold the bottle with the cap, aim directly and insert it into the fill hole of the cartridge toner chamber.10. Toner should flow freely into the toner chamber. Should toner refuse to flow, take off the funnel cap, reseal the toner bottle with the cap and jar the replacement bottle over the flat surface again. Continue the transfer of toner.11. Once toner transfer is completed, reseal the fill hole. Use the same plastic cap that was pried open previously. Secure a tight and leak-free seal by placing a duct tape over the fill plug12. Clean the Samsung ML2010D3 cartridge of residual toner use the toner wipe that comes regularly with a toner refill kit.
  4. 4. 13. Pull out the used reset fuse from the cavity and insert the new fuse that comes with the kit. 14. The printer cartridge refill process is now complete. Shake the cartridge slightly from left to tight to distribute toner evenly inside the cartridge. Reload the freshly refilled cartridge back into the printer and print.Notes:  The refilled cartridge will refuse to print if the reset fuse is not replaced.  As a precaution against toner stains wear the accompanying latex gloves during the refill process.

×