How do i enable power over ethernet on a cisco 3560
Upcoming SlideShare
Loading in...5

Like this? Share it with your network


How do i enable power over ethernet on a cisco 3560



Leading Cisco networking products

Leading Cisco networking products



Total Views
Views on SlideShare
Embed Views



0 Embeds 0

No embeds



Upload Details

Uploaded via as Microsoft Word

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
Post Comment
Edit your comment

How do i enable power over ethernet on a cisco 3560 Document Transcript

  • 1. How do I Enable Power Over Ethernet on a Cisco 3560? PoE (Power over Ethernet) is a wonderful feature in many network switches that provides power and network connectivity to PoE enabled devices over a single network connection cable. In some cases, PoE will need to be configured on a Cisco 3560 when plugging in a PoE enabled device in order to use this feature. Instructions 1 Plug a Cisco serial console cable into the 9-pin serial port on the back of a computer and the other end of the serial cable into the serial console port on the Cisco 3560X. 2 Open the terminal console program---for example Hyperterminal or Putty in Microsoft Windows or Minicom in Linux---and configure the terminal console program to connect at 9600 baud, or "bits per second," with flow control configured for "None." Sponsored Links Data Center of the Future Tackle Data Challenges and Become Converged, Virtualized, & Automated 3 Press the "Enter" key several times and the Cisco command prompt will display. Type "enable" and press the "Enter" key, then type the enable password if requested and press the "Enter" key. 4 Type "config t" and press the "Enter" key to access global configuration mode. 5 Type "interface fastethernet 0/2," replacing "fastethernet 0/2" with the name of a PoE port you wish to enable, and press the "Enter" key. Type "power inline auto" on the command line, and press the "Enter" key. Repeat for each PoE port you wish to enable. 6 Type "exit" and press the "Enter" key when all PoE ports have been enabled, then type "exit" and press the "Enter" key. Type "copy run start," and press the "Enter" key to save the new configuration settings. —Original resource from is a world leading Cisco networking products wholesaler, we wholesale original new Cisco networking equipments, including Cisco Catalyst switches, Cisco routers, Cisco firewalls, Cisco wireless products, Cisco modules and interface cards products at competitive price and ship to worldwide. Our website: Telephone: +852-3069-7733 Email: Address: 23/F Lucky Plaza, 315-321 Lockhart Road, Wanchai, Hongkong 1