Alternative refill method for Canon Pixma cartsSupplies needed:          syringe with a longer needle,          sharp obje...
Upcoming SlideShare
Loading in …5
×

Alternative refill method for canon pixma carts

1,077 views
1,004 views

Published on

Alternative refill method for canon pixma carts

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
1,077
On SlideShare
0
From Embeds
0
Number of Embeds
5
Actions
Shares
0
Downloads
1
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Alternative refill method for canon pixma carts

  1. 1. Alternative refill method for Canon Pixma cartsSupplies needed: syringe with a longer needle, sharp object that will make a hole in the cartridge (awl, needle, sewing).Drill a hole in the cartridge of sufficient diameter for inserting a syringe needle into the chamberwith a sponge (indicated by a red line in the figure).Turn the cartridge so that the ink outlet is facing upward. Push the needle through the hole as close toplastic that separates cartridge into the two parts (the part with and without sponge).Fill the cartridge with ink until the chamber without the sponge is full. Occasionally you can turncartridge so that ink outlet is facing down and leave it for a while in order to better saturate spoongewith ink, and then turn it back and continue to recharge.When you refilled the cartridge, check the hole you made on the cartridge. If the hole is sufficientlysmall diameter, the ink will not leak out of it and the cartridge can thus be used, otherwise seal thehole with duct tape or screw, rubber plug etc. source: www.refillbros.com

×