How to Install a Camera on a Car?                                                                            by qualir - h...
Upcoming SlideShare
Loading in...5

How to-install-a-camera-on-a-car


Published on

Qualir Automobile Electronics Co., LTD, founded in 1998, aims to create automobile owners's drive more quickly and cosily by providing automobile electronics of Good quality and Reliability. In May 1998, Qualir started to create and generate Car CD, VCD Players and property CD,DVD Players. In March 2003, Qualir began to develop and create Automobile Mp3 players,Car DVD Players,and effectively developed Auto DVD Players with Built-in GPS function in 2004. In June 2007, Qualir made the decision to create a platform for direct wholesale of Auto electronics. In September 2007, Qualir's wholesale Dept was successfully founded and our on the internet wholesale shop was lastly completed.

  • Be the first to comment

  • Be the first to like this

No Downloads
Total Views
On Slideshare
From Embeds
Number of Embeds
Embeds 0
No embeds

No notes for slide

How to-install-a-camera-on-a-car

  1. 1. How to Install a Camera on a Car? by qualir - date:2011-11-18 How to Install a Camera on a Car? 2011-06-13 09:53:28 By qualir As you know, the car DVD GPS player could be connected with a camera to build up a parking system. In theory, all of the DVD players could support the rear camera input. The question is how? Here are the steps: First you need to decide where you want to install the camera. Many people put them in the plastic bumper. And it doesn’t need them to drill into the car’s sheet metal. There are some kind of special cameras need to drill a hole of the bumper, since they are designed for the special cars. It fits to the back light exactly. Such as Mitsubishi lancer camera and BMW camera. These special cameras need you to confirm where you will install them, because these cameras could be hidden as original after installation. Second, you need to drill a hole for the camera. Check the installation instructions first to see the size. Remember that do not make the hole too large otherwise the camera will fall out. You could place the cameras in the hole for using the rubber grommet supplied with the camera. You need to make sure the camera and grommet are tight. Connect the camera’s power wire to the backup light power wire on your car. You need to connect the wires together. You could use wire cutters to cut the wires, leaving enough excess wire to reconnect. You need to strip the ends of the wire to expose the bare wire using wire strippers. Splice the wires together using a two-into-one connector. It could supply the rear-view camera power when you put the car in reverse. Original article page link: page 1 / 1Powered by TCPDF (