• Share
  • Email
  • Embed
  • Like
  • Save
  • Private Content
 

DIY Double Glazing Repairs - How Replace a Double Glazed Unit

on

  • 3,928 views

http://doubleglazingdiy.net Double Glazing Repairs - How Replace a Double Glazed Unit. For a Complete DIY Double Glazing Blueprint Click Here http://doubleglazingdiy.net ...

http://doubleglazingdiy.net Double Glazing Repairs - How Replace a Double Glazed Unit. For a Complete DIY Double Glazing Blueprint Click Here http://doubleglazingdiy.net

www.youtube.com/watch?v=CMGRPMBfYBQ‎

Statistics

Views

Total Views
3,928
Views on SlideShare
3,928
Embed Views
0

Actions

Likes
0
Downloads
1
Comments
0

0 Embeds 0

No embeds

Accessibility

Upload Details

Uploaded via as OpenOffice

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

    DIY Double Glazing Repairs - How Replace a Double Glazed Unit DIY Double Glazing Repairs - How Replace a Double Glazed Unit Presentation Transcript

    • How To Glaze a upvc Window www.DoubleGlazingRepairsLeeds.co.uk
    • To Glaze The Window You Must First Remove The glazing Beads That Hold The Old Glass In Place, This Enables You To Remove The Old One & Fit The Replacement Glass.
    • Most Windows Nowadays Are Internally Glazed So Your Beads Should Be On The Inside Located All Around The Frame. Use a Chisel Or Putty Knife To Remove Them & Take Note How They Come Out This Will Help When You Put Them Back In.
    • Firstly Place 2 Glazing Packers On The Bottom Of The Frame Where The Glass Is Going To Sit Making Sure Not To Trap The Packer Behind The Internal Pane. As This Can Cause The Glass To Break When You Hammer The Beads Back Into Place.
    • Tip! **************************************************** Angle the packers so they protrude the glass slightly, This Prevents Them From Getting Trapped & Causing Damaged. ****************************************************
    • Take The Top Bead & Place It In Position Then Using Your Thumb Just Above The Black Rubber Gasket & Push So As To Compress The Gasket Onto The Glass Then Tap The Bead Into Place With a Plastic Glazing Mallet. You Have To Work Along The Bead Following This Procedure.
    • This Type Of Bead Is Called The Hook Bead The Compression Puts The hook In The Correct Position To Be Easily Tapped Into Place. If You Have It In Correctly It Should Be a Nice Tight Fit, If It’s Loose It’s Not In Correctly.
    • Do Exactly The Same For The Bottom Bead & Then The Sides. If all For Beads Are Mitred You Will Have To Bend The Two Side Beads Into The Corners & Then Tap Them home.
    • Tip! **************************************************** Top bead first this will hold in the glass while you reach for your next Bead which should be the bottom one. ****************************************************
    • Go Here For www.DoubleGlazingRepairsLeeds.co.uk Or For a Complete Guide To DIY Double Glazing Go Here www.howtofitawindow.com