1. RESUME
HILARY OGBEKILE.
8 Aleruchi Close,Off Ada George Road, Mgbuoba, Port-Harcourt, Rivers State,
Nigeria, West Africa.
TEL:+ 234 (0)8035062882 OR 234(0)8037055835
E-Mail: ogbekilehilary@gmail.com OR iyko2000@yahoo.com
SUMMARY OF EXPERIENCE:
B.Eng in Mechanical Engineering, experience QA/QC mechanical. piping ,structural, coating ,welding ,fit up
,material ,consumable and hydro test inspection with Industrial training in Air condition maintenance, inspection
and repairs, heavy duty engine inspection, servicing, dismantle and re-assemling, etc. confident in the use of
computer soft ware’s including but not limited to MS Office.
PERSONAL DATA:
Date and Place of Birth: 15st
September 1984. Agbor, Delta State-Nigeria.
Sex: Male
Nationality: Nigerian
Marital Status: Married
EDUCATIONAL DATA:
• American Society For Non Destructive Testing.(ASNT)- 2014
• Offshore safety training centre (2013)
• Joint Professionals Training & Support (JPTS) (2011)
• Federal University of Technology, Owerri (FUTO) Imo State, Nigeria (2004-
2009)
• Bishop Crowder Memorial Secondary School, Port-Harcourt, Rivers State,
Nigeria (1998-2003).
• Alizomor Primary School, Agbor, Delta State, Nigeria (1993-1998)
QUALIFICATIONS OBTAINED:
• Radiographic Film Interpretation- ASNT LEVEL 2 (2014)
• Magnetic Particle Testing- ASNT LEVEL 2 (2014)
• Survival At Sea (SAS) - (2013)
• Swing Rope (SRT) - (2013)
• NATIONAL YOUTH SERVICE CORP ( NYSC)- (2010-2011)
• Level 1 & 2 certificate in Occupational Health, Safety & Environment (2011)
• B.Eng Mechanical Engineering (2004-2009)
• West Africa Examination Council (WAEC) & National Examination
Council(NECO) – (2003).
• First School Leaving Certificate (FSLC)-(1998)
WORK EXPERIENCE: FROM 2011 TILL DATE
TOMBIM SERVICES LIMITED
• Position; QA/QC Inspector
• Job Responsibilities Covered; Control and distribution of all quality
Document.
• Ensuring Conformance to specified procedures, Specifications,
Standards and codes,
• Material inspection.
Ensure the use and proper implementation of only qualified and approved
welding procedure during production welding.
• Perform weld numbering.
2. • Perform welding inspection during welding procedure qualification test and
welding procedure during production welding.
• Perform fit-up inspection and alignment of fit-up pipes according to procedure
and specifications.
• Ensure welding materials and Equipment are in good condition.
• Ensure welding parameters are within the applicable range of the specified
WPS.
• Monitor pre- heat and inter-pass temperature.
• Ensure the use of only qualified welders and operators.
• Perform visual inspection of completed welds.
• Maintain and record daily welding inspection reports.
• Hydro test and coating inspection.
• Lead test inspection.
• Document for operation (D.F.O) arrangement.
GOVERNMENT SECONDARY SCHOOL, YELDU, KEBBI .STATE.
• Position; Teacher.
• Job Responsibilities Covered;
• Mathematics teacher (J.S.S 2).
OKMAS NIGERIA LIMITED, RIVERS STATE, NIGERIA (2006)
• Position: Industrial Trainee
• Job Responsibilities Covered:
• Heavy duty engine maintenance, inspection and repairs
• Heavy duty engine general servicing; dismantling and re-assembling
• Logging of equipment maintained into equipment maintenance log book.
• Taking of inventory.
OKMAS NIGERIA LIMITED, RIVERS STATE, NIGERIA
(2008)
• Position: Industrial Trainee
• Job Responsibilities Covered:
• Air condition maintenance, inspection and repairs.
• Gas welding and installation of air condition.
• Logging of equipment maintained into equipment maintenance log book.
• Taking inventory.
PROJECTS HANDLED AND RESPONSIBILITIES.
UBIT GY PIGGING FACILITY AND FUEL GAS UPGRADE PHASE 11
(2015)
• Material Inspection
• Perform Fit-up Inspection And Alignment
• Welding Inspection(inspection before welding, during welding and after
welding)
• Preparation Of daily Welding Reports.
• Parameters Check If Within The Applicable Range Of The Specified WPS.
• Hydro Test Inspection.
• Painting Inspection.
INIM LIFE EXTENSION (PRE-SHOTDOWN, SHOTDOWN
AND PRO-SHOTDOWN PROJECT-2014 )
• Preparation Of Installation Matrices
• Welding Inspection
• Dimensional control/fit up
3. • Hydro test and lead test Inspection
ASASA VB PIPING INSTALLATION (2014)
• Installation matrices
• Welding inspection
• Dimensional control/fit up monitoring.
• Coating inspection
ASASA VB DECK INSTALLATION (2013)
• Welding inspection
• Dimensional control/fit up monitoring
• Coating inspection.
OYOT 2A GASLIFT PROJECT( MPN) (2013)
• FABRICATION OF SPOOL.
• Dimensional control/fit up monitoring.
• Welding inspection.
• Hydro test inspection
• Coating inspections
ETIM LIFE EXTENSION REPAIRS PROJECT (MPN) (2013)
• FABRICATION OF MONORAIL.
• Dimension control/fit up monitoring inspection
• Welding inspection.
• Coating inspection.
ASASA VB DECK EXTENSION (OFFSHORE MPN) (2013)
• Welding inspection
• Coating inspection
• Dimensional control/fit up monitoring
EMERGENCY TRUNK LINE PROJECT (QIT 2013)
UBIT/EDOP LINE.
• MODIFICATION OF SPOOLS
• Welding inspection
• Dimensional control/fit up monitoring.
• Hydro test inspection.
• Painting inspection.
ETLP QIT IDOHO LINE PIPE SUPPORT (MPN 2013)
• Painting Inspection.
• Check/fit up monitoring
INIM PIGGING FACILITY UPGRADE ,PHASE 1 ( OFFSHORE; MPN 2013)
• Welding inspection
• Painting inspection
• Material inspection
• Dimensional control/fit up monitoring
INIM LIFE EXTENSION REPAIRS PROJECT,PHASE 2 (MPN ONSHORE)
• Fabrication of INIMI IA/IP Spools
• Hydro test inspection
• Painting inspection
• Welding inspection
• Dimensional control/fit up monitoring
ASABO RESTORATION PROJECT PHASE 2 (MPN ONSHORE 2013)
• Fabrication of Asabo phase 2 spool
• Welding inspection
4. • Hydro test inspection
• Painting inspection
PERSONAL SKILLS AND QUALITIES:
• Think and act quickly.
• Always willing to help others
• Strive against oppression.
• Self-starter with strong communication skill.
• Recognize and analyses various options simultaneously.
• Relate well to others and work with a large number of people
• A demonstrated ability to lead, manage and inspire team.
• Can adapt to any weather or geographical location.
HOBBIES:
Football, Listening to music and Reading.
REFEREES:
1. Ajoku Samuel 3. Mr. Clement Isibor
Tombim Services Limited 08064040611
QA/QC Coordinator. NPOC-Pipeline Programme
Phone ;08033139761 Exxonmobil Production Nigeria Unlimited
Iyke Ogbekile
HSE coordinator
West Africa venture
Email: iyko2000@yahoo.com
Phone: 08037055835, 080640406112.
.
.
. .