CNT-based NEMS have been demonstrated by various groups.
Prototype devices:
Oscillators
nanorelays
sensors
nanotweezers.
NEMS switches are believed to have
low masses
high mechanical quality factors
high isolation
lower losses
(Top): CNT nanotweezer. (Bottom): Schematic of cantilever type CNT based switch.
Low-Level measurement Setup for Carbon Nanotube Use of Guard connections of SMU with triaxial cable & for voltage measurement in a coaxial cable Ref.: Keithley Low Level Measurement Handbook
Test setup for low level measurement signal was developed.
Current measurements as low as 1pA
Voltage measurements upto 100 V
Resistance measurements as high as 10G Ω
Use of faraday cage to eliminate high frequency disturbances, guard connection in triax cables.
Elimination of possible sources of disturbances and external noise interferences during test-setup.
Proper DAQ using LabVIEW and signal conditioning & filtering.
Avoid ground loops and proper isolation of various instruments as well as earthing to prevent ESD.
Front Panel of Nano-switch Test Software
Setup to interface Semiconductor Parametric Analyzer, Function Generator, SMU, Lock-in Amplifier and Oscilloscope.
Statistical data analysis and plotting of test results on-the-go for precise control of testing parameters.
Proper record of time, location and chip details stored in the data file.
Moment of electrostatic actuator for MEMS Modeling
Dynamic Equation of Motion for Simulation - MEMS Switch
Fabrication of Electro-hydro dynamic Micropump of flexible parylene substrate for IC Fabrication coursework.
The flexible substrate technology can be used for building future flexible TFT screens.
Parylene-C is bio-compatible substance and can be used for biomedical devices.
Masters in Electrical Engineering, Northeastern University Semiconductor Device Engineering Product Integration Engineer Test & Reliability (Failure Analysis) Graduate Research Assistant SEM AFM Characterization Specialist less
1 comments
Comments 1 - 1 of 1 previous next Post a comment