One way to quickly draw a door-AUTOCAD
Upcoming SlideShare
Loading in...5
×
 

One way to quickly draw a door-AUTOCAD

on

  • 563 views

 

Statistics

Views

Total Views
563
Slideshare-icon Views on SlideShare
563
Embed Views
0

Actions

Likes
0
Downloads
0
Comments
0

0 Embeds 0

No embeds

Accessibility

Upload Details

Uploaded via as Adobe PDF

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

    One way to quickly draw a door-AUTOCAD One way to quickly draw a door-AUTOCAD Document Transcript

    • One way to quickly draw a door Lets say that you have a 5 inch thick wall with a 36 inch opening that you need to add a door to, This method will work with any size opening, but adjust it for thick walls. STEP 1 - Draw a rectangle from the 'hinge point' to the middle of the other opening side. UG-CE-2010 Lec .Sana Khan
    • STEP 2 -Now rotate the door 45 degrees. Some drawings might have doors rotated at 90 degrees. STEP 3 -Draw a circle from the 'hinge point' to the other side. This will be trimmed to an arc soon. UG-CE-2010 Lec .Sana Khan
    • STEP 4-Draw a line from the hinge point past the radius of the circle at 55 degrees. (Notice I used polar coordinates there? STEP 5-Now you need to trim the arc down to what you need it to be. Select you cutting edges (highlighted below) and trim the arc where shown. UG-CE-2010 Lec .Sana Khan
    • STEP 6-Finally, erase the line you drew and you're left with a door that indicated the swing as well. UG-CE-2010 Lec .Sana Khan