Your SlideShare is downloading. ×
PermaTherm Insulated Metal Panel Manufacturing Tolerances
Upcoming SlideShare
Loading in...5
×

Thanks for flagging this SlideShare!

Oops! An error has occurred.

×
Saving this for later? Get the SlideShare app to save on your phone or tablet. Read anywhere, anytime – even offline.
Text the download link to your phone
Standard text messaging rates apply

PermaTherm Insulated Metal Panel Manufacturing Tolerances

26

Published on

PermaTherm Insulated Metal Panel Manufacturing Tolerances

PermaTherm Insulated Metal Panel Manufacturing Tolerances

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total Views
26
On Slideshare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
0
Comments
0
Likes
0
Embeds 0
No embeds

Report content
Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
No notes for slide

Transcript

  • 1. 269 Industrial Park Rd. PermaTherm Monticello, GA 31064 {p} (706) 468-7500 269 Industrial Park Rd. | Monticello, GA 31064 {f } (706) 468-7510 Insulation Innovation {p} (706) 468-7500 | {f} (706) 468-7510 (866) 468-7510 {e} info@permatherm.net {e} permatherm@earthlink.com Panel Manufacturing Tolerances Length Up to 20 ft: ± 1/8 in. Over 20 ft.: ± 3/16 in. Width ± 1/8 in. Thickness ± 1/8 in. Squareness ± 1/8 in. (measured 6 in. from end) Lateral Bow Up to 10 ft. ± 3/32 in. 10 ft. to 20 ft.: ± 3/16 in. Over 20 ft.: ± 3/8 in. Flatness ± 3/16 in. per 2 ft. spanJoints Male/female joint edges flush, with not more than 1/8 in. deviationFinish Panels free of surface imperfections (dents, mars, scratches, etc.) visible with panel in position ofintended use and view under good light from intended installed distance or 8 ft., whichever is greater.Other Manufacturing GuidelinesPermaTherm Architectural Insulating Panels are designed to carry specified total loads, with maximumcomputed buckling stress not to exceed the maximum allowable buckling stress of the facings.The inside face of all panels must be cut at girt attachments to avoid compression bucking of the exteriorskin.Wherever interior panel skins are extended to the outside (warm side) surface, a thermal break must be cutto avoid thermal conductivity.Block panel packages should be stored above ground to keep out of water, and on a sloped surface toprovide drainage. Contents and logo are property of PermaTherm, Inc.page 1 All rights reserved. Copyright 2005 ©

×