Your SlideShare is downloading. ×

Led bracelet instructions

768
views

Published on

Published in: Business, Technology

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total Views
768
On Slideshare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
3
Comments
0
Likes
0
Embeds 0
No embeds

Report content
Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
No notes for slide

Transcript

  • 1. LED BraceletInstructions
  • 2. MaterialsYou will need: 1 strip of felt 1 LED Condutive thread Regular thread 1 CR2032 battery 1 battery holder 1 LED Decorations Sewing needle and scissors
  • 3. LED’sLight Emitting Diodes Emit light when electricity runs through them Only work if the electricity is going in the right direction If you connect the long wire to the positive side of the battery and the short wire to the negative side, it works Connect it the wrong way, though, and nothing happens
  • 4. Step 1: trim the felt to fit your wrist
  • 5. Step 2 – add snapsUsing conductive thread,sew one half of the snapnear the end of the strip(sew lots of conductivethread through the loops ofthe snap to make a goodconnection when the snapcloses)On the back side of the stripsew the other half of thesnap so that when the stripis closed in a circle, the twohalves snap together
  • 6. Step 3 – add lightCut a slit in the strip for theLED lighsPoke the LED light bulbthrough the hole so themetal is on the back and thebulb is on the front of thebracelet
  • 7. Sew lights & battery holder On the back of the bracelet, sew the positive (square) side of the LED to one of the snaps Sew the positive side of the battery holder (the one with the three plastic prongs) to the other snap Sew the negative (round) side of the LED to the negative side of the battery holder Slip the battery into the battery holder negative (rough) side down
  • 8. DecorateAdd decorations to thefront of the bracelet –fabric glue or felt glue isgreat for thisSnap the bracelet on yourwrist and watch it light up