Raindrop earrings

254 views

Published on

0 Comments
1 Like
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total views
254
On SlideShare
0
From Embeds
0
Number of Embeds
3
Actions
Shares
0
Downloads
6
Comments
0
Likes
1
Embeds 0
No embeds

No notes for slide

Raindrop earrings

  1. 1. RRRRRRRRRRRRRRRRRRRRRRRRRRRprojectlibrary Raindrop Earrings By JENNA COLYAR-COOPER of FusionBeads.com Coiled drops frame big beads. MATERIALS: 26-gauge fine silver wire, 6 20mm x 14mm sterling round teardrop component, 2 10mm round beads, 2 Earwires TOOLS: All photos courtesy of FusionBeads.com Chain nose pliers Flush cutters RESOURCES: All materials from FusionBeads.com TECHNIQUES: Wirework, wirewrapping, coiling, beading. Step 1: Anchor 3 of the wire to one of the components at the largest width of the teardrop. Copyright Interweave Not to be reprinted. All rights reserved. page 1 publishers of Step by Step Wire Jewelry magazine . . . join the online beading community at www.BeadingDaily.com
  2. 2. Raindrop Earrings Step 2: Coil the wire around the bottom of the Step 4: Cut both tails of the wire. Open the loop in the component until you reach the same part of the earwire and add the wrapped component. Close component on the opposite side. Thread the the loop. Repeat for the other earring. bead onto the wire, take the wire across the teardrop, so the bead sits in the middle and coil once onto the frame. Step 3: Coil the wire around the other side of the component. Continue wrapping up and around the component until it is completely covered. Copyright Interweave. Not to be reprinted. All rights reserved. page 2 publishers of Step by Step Wire Jewelry magazine . . . join the online beading community at www.BeadingDaily.com

×