Upcoming SlideShare
×

# Isometric

3,626 views

Published on

Published in: Technology, Art & Photos
1 Comment
0 Likes
Statistics
Notes
• Full Name
Comment goes here.

Are you sure you want to Yes No
• so nice it is and it is helping me in teaching the ITI students

Are you sure you want to  Yes  No
• Be the first to like this

Views
Total views
3,626
On SlideShare
0
From Embeds
0
Number of Embeds
8
Actions
Shares
0
168
1
Likes
0
Embeds 0
No embeds

No notes for slide

### Isometric

1. 1. ISOMETRIC SKETCHES
2. 2. • What angle do isometric axes make with each other?
3. 3. • What angle do isometric axes make with each other? • 120 degrees
4. 4. • What are isometric lines versus non-isometric lines? What type of edges would you draw with both
5. 5. • What are isometric lines versus non-isometric lines? What type of edges would you draw with both • Isometric lines are parallel to the isometric axes and are used to draw normal edges • Non-isometric lines are NOT parallel to the isometric axes and are used to draw inclined and oblique edges
6. 6. • Explain the offset location measurement method. What types of surfaces would you draw using this method?
7. 7. • Explain the offset location measurement method. What types of surfaces would you draw using this method? • Method used in isometric drawing to locate points with respect to each other using rule of parallelism. Normal, inclined, and oblique can be drawn using this method.
8. 8. • True or False. A 30, 60, and 90 degree angle triangle is shown on a multi-view. The same angles will transfer directly to the isometric view.
9. 9. • True or False. A 30, 60, and 90 degree angle triangle is shown on a multi-view. The same angles will transfer directly to the isometric view. • FALSE. None of the angles will be the same in the isometric view. Locate the points of the triangle using dimensions rather than using angles when drawing the isometric view.
10. 10. • True or False. Hidden lines and centerlines are used in isometric Drawings
11. 11. • True or False. Hidden lines and centerlines are used in isometric Drawings • FALSE (or True in a way?) Hidden lines and centerlines should be used sparingly. If in doubt, leave them out.