GeoVision : Intergation Solutions : GV-NVR and Access Control with PTZ preset on camera

792 views
715 views

Published on

GeoVision : Intergation Solutions : GV-NVR and Access Control with PTZ preset on camera

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
792
On SlideShare
0
From Embeds
0
Number of Embeds
3
Actions
Shares
0
Downloads
3
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

GeoVision : Intergation Solutions : GV-NVR and Access Control with PTZ preset on camera

  1. 1. How to set PTZ Preset Function with GV-AS200 Controller Article ID: GV-33-08-07-10 Release Date: 2008/7/10Applied toGV-AS200 ControllerSummaryGV-AS200 Controller can work in conjunction with the PTZ camera to perform presetfunctions on two doors. In this application, one PTZ camera is connected to both outputs ofDoor B and Door D on the GV-AS200 module. When Door A is opened, the signal of WiegandA will be transmitted to Wiegand B (Door B) and it will trigger the PTZ camera view moving toDoor A. When Door C is opened, the signal of Wiegand C will be transmitted to Wiegand D(Door D) and it will trigger the PTZ camera view moving to Door C.Requirements4-door modules: GV-AS200-4 or GV-AS200-4ETo Connect a PTZ to GV-AS200 Controller 1. The work mode of GV-AS200 Controller must be set to One Way Control. By default, the work mode is One Way Control. If the default setting has been changed, use GV-ASKeypad to modify it.GeoVision Inc. 1 Revision Date: 2008/7/21
  2. 2. 2. Connect the card reader to the Wiegand A inputs. Then connect the D0 and D1 pins of Wiegand A with the two same pins of Wiegand B, as illustrated below. GND BZ RL GL D1 D0 12V GND BZ RL GL D1 D0 12V 3. Connect the Door + pin of Door B outputs to the Input 1 pin of PTZ. Then connect the Urgent 1 pin of Door B outputs to the Ground pin of PTZ, as illustrated below. Please note don’t connect any power to the Door B outputs. 4. Set the Door Relay Switch of Door B to NO.GeoVision Inc. 2 Revision Date: 2008/7/21
  3. 3. 5. Connect the card reader to the Wiegand C inputs. Then connect the D0 and D1 pins of Wiegand C with the two same pins of Wiegand D, as illustrated below. GV-Reader Wiegand D Wiegand C 6. Connect the Door + pin of Door D outputs to the Input 2 pin of PTZ. Then connect the Urgent 1 pin of Door D outputs to the Ground pin of PTZ, as illustrated below. Please note don’t connect any power to the Door D outputs. 7. Set the Door Relay Switch of Door D to NO.GeoVision Inc. 3 Revision Date: 2008/7/21
  4. 4. 8. It is required to allow the accessibility of Door B and Door D even though only Door A and Door C are used for entry and exit.GeoVision Inc. 4 Revision Date: 2008/7/21

×