Issues with screen_saver
Upcoming SlideShare
Loading in...5
×
 

Issues with screen_saver

on

  • 422 views

Issues with screen_saver

Issues with screen_saver

Statistics

Views

Total Views
422
Views on SlideShare
422
Embed Views
0

Actions

Likes
0
Downloads
0
Comments
0

0 Embeds 0

No embeds

Accessibility

Categories

Upload Details

Uploaded via as Adobe PDF

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

Issues with screen_saver Issues with screen_saver Document Transcript

  • Issues with channel screen display after the screen saver stopped, or the computer left standby or hibernation modes Article ID: GV-15-08-07-14 Release Date: 7/14/2008Applied toGV-Video Capture Cards, including GV-600, GV-650, GV-800, GV-1120, GV-1240, GV-1480,GV-2004 and GV-2008SymptomsAfter the screen saver was stopped or the computer left standby or hibernation modes, theimages on channel screens were not displayed at all or with poor quality.Of Screen SaverIf the screen saver had no password protection, the channel screens would function normallyafter the screen saver was stopped.However, if the password protection was activated, the channel screens would turn pink orblack when these conditions were true: DSP Overlay function was activated. GV-1120, GV-1240, GV-1480, GV-2004 or GV-2008 was installed.Note that recording files were not affected if the GV-System was monitoring.GeoVision Inc. 1 Revision Date: 7/14/2008
  • Of Standby or HibernationThe symptoms varied by the type of the installed GV-Video Capture Card. On the computer where GV-1120, GV-1240, GV-1480, GV-2004 or GV-2008 was installed, this symptom occurred: After the computer left standby or hibernation modes, all channel screens had lost video signals. No signals Even after the GV-System was restarted, the images displayed were all mosaic. Mosaic images On the computer where GV-600, GV-650 or GV-800 was installed, this symptom occurred: After the computer left standby or hibernation modes, all channel screens turned black.GeoVision Inc. 2 Revision Date: 7/14/2008
  • SolutionsTo solve the issues with screen saver:Restart the GV-System, and you will find the channel screens are back to normal.To avoid experiencing this problem again, it is recommended that you should follow thesesteps to cancel password protection.1. Right-click the desktop, and then click Properties.2. In the Display Properties dialog box, click the Screen Saver tab, clear the selection of On resume, password protect, and then click OK.GeoVision Inc. 3 Revision Date: 7/14/2008
  • To solve the issues with standby and hibernation:The solutions vary by the type of the installed GV-Video Capture Card. On the computer where GV-1120, GV-1240, GV-1480, GV-2004 or GV-2008 is installed, restart the computer. On the computer where GV-600, GV-650 or GV-800 is installed, restart the GV-System.However, to avoid experiencing this problem again, it is recommended that you should not putyour computer in standby or hibernation modes. To cancel hibernation, follow these steps:1. On Click Start, click Settings, click Control Panel, and then click Power Options.2. In the Power Options Properties dialog box, click the Hibernate tab, clear the selection of Enable hibernation, and then click OK.GeoVision Inc. 4 Revision Date: 7/14/2008