1. NETW420 Week 7 iLab 7
Click this link to get the tutorial:
http://homeworkfox.com/tutorials/general-
questions/8333/netw420-week-7-ilab-7/
Copy this panel to your answer sheet. After the initial oscillations, what is the average database
response time and what is the average HTTP page response time?
Copy this panel to your answer sheet. What does the panel tell us about the utilization on this
link?
What was the range (low to high) in bytes per second (or Kbytes per second) of database traffic
received by the users for the No_Redundancy run?
What was the range (low to high) in bytes per second (or Kbytes per second) of database traffic
received by the users for the Redundancy_Loadbalance run?
What was the range (low to high) in bytes per second (or Kbytes per second) of database traffic
received by the users for the DS1_Link Failure run?
In your estimation, was the amount of database traffic received by the users approximately the
same for all three runs?
For the No_Redundancy run, estimate the average Database Query response time in seconds (or
milliseconds).
For the Redundancy_Loadbalance run, estimate the average Database Query response time in
seconds (or milliseconds).
For the DS1_Link_Failure run, estimate the average Database Query response time in seconds
(or milliseconds).
For the estimated time values you assigned in the answers to questions (7), (8), and (9) above,
which run had the longest response time? Explain why. Which run had the shortest response
time? Explain why.
What was the range (low to high) in bytes per second (or Kbytes per second) of HTTP traffic
received by the users for the No_Redundancy run?
What was the range (low to high) in bytes per second (or Kbytes per second) of HTTP traffic
received by the users for the Redundancy_Loadbalance run?

2. What was the range (low to high) in bytes per second (or Kbytes per second) of HTTP traffic
received by the users for the DS1_Link Failure?
. In your estimation, was the amount of HTTP traffic received by the users approximately the
same for all three runs?
For the No_Redundancy run, estimate the average HTTP page response time in seconds (or
milliseconds).
For the Redundancy_Loadbalance run, estimate the average HTTP page response time in
seconds (or milliseconds).
For the DS1_Link_Failure run, estimate the average HTTP response time in seconds (or
milliseconds).
For the estimated time values you assigned in the answers to questions (15), (16), and (17)
above, which run had the longest response time? Explain why. Which run had the shortest
response time? Explain why.
What was the percent range (low to high) of the DS1 link utilization for this run?
What was the percent range (low to high) of the DS1 link utilization for the link that connects the
WAN provider to Router A for this run?
What was the percent range (low to high) of the DS1 link utilization for the link that connects the
WAN provider to Router B for this run?
What was the percent range (low to high) of the DS1 link utilization for the link that connects the
WAN provider to Router A for this run?
. What was the percent range (low to high) of the DS1 link utilization for the link that connects
the WAN provider to Router B for this run?
Write a one- to two-page Summary Report that answers the following: Did the
implementation of the Fault Management design used in this lab accomplish these goals? To help
support your analysis, you should reference some of your answers from the required lab question
section. In addition, you must import a minimum of two graphs that you obtained during this lab
to help support your conclusions.