iMovR ZipLift Installation Instructions

275 views

Published on

Follow these steps to set up your iMovR ZipLift. You'll be standing in no time!

Published in: Devices & Hardware
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
275
On SlideShare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
0
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

iMovR ZipLift Installation Instructions

  1. 1. 5230180 Rev. A INSTALLATION / INSTRUCTIONS DESK MOUNT SIT-STAND WORKSTATION WEIGHT CAPACITY - A + B ≤ 35 lbs. HEIGHT ADJUSTMENT KEYBOARD TILT ADJUSTMENT Squeeze levers on both sides simultaneously to move workstation up and down to desired height. Release levers to lock the workstation into position. The product will not be activated when squeezing only one lever. While holding the tray, loosen knob slightly. Set and hold tray at desired tilt angle and re-tighten knob. B ≤ 5 lbs. A ≤ 35 lbs. ! Maximum weight capacity is 35 lbs. Serious injury or property damage may occur if maximum is exceeded. Make sure all cord lengths are sufficient to use with this product. IMPORTANT INFORMATION Lift the workstation out of the box, do not squeeze the levers until after the product is in place. -10°/+10° tilt

×