Issued by the Produc t Managem ent Group WT Divis C ion COOL SOLV - SRWT 1121.. ANTISCALANTDescription Cool Solv SRWT-1121 is a concentrated liquid formulation containing organic polymers.Uses Cool Solv SRWT-1121 inhibits scale formation in R.O. and Thermal Desalination Systems due to calcium carbonate, calcium sulphate and barium sulphate and strontium sulphate deposits with little or no acid feed. The product works through crystal distortion and sequestration mechanism.Features Cool Solv SRWT-1121 is completely water soluble. It has effective deposit prevention capability even at highly alkaline pH Unlike the phosphate based scale inhibitor Cool Solv SRWT-1121 works at significantly low dosage level. It is also more versatile because it can prevent deposits of both carbonate & sulphate salts of Calcium, Barium and Strontium. The product is compatible with all types of membrane and will not violate membrane warrantees. The product is highly effective in any Thermal Desalination system.Applications Cool Solv SRWT-1121 is a specially designed chemical program for excellent deposit control in reverse osmosis (RO) and Thermal Desalination systems.Dosage Cool Solv SRWT-1121 dosage generally varies from 3 to 15 ppm. Exact dosage level depends on the type of membrane and the system dynamics / characteristics. For potable drinking water system- maximum permissible dosage level is 10 mg/litre. Cool Solv SRWT-1121 should be fed through a pump to a membrane system prior to the final cartridge filter. If media filtration or activated carbon is used, polymer should be applied after these treatment stages. In case of Thermal Desalination systems the feed point will be at the feed water intake line.Typical Odor and Appearance : Clear Yellow/Brownish liquid withProperties characteristics odor Sp. Gravity : 1.271 at 250C Boiling Point : 1040C Solubility : Highly Soluble PH : 11.0 - 11.5Benefits Cool Solv SRWT-1121 prolongs membrane life and thus lengthens the time between membrane cleanings. It also eliminates or minimizes acid feed. In case of Thermal Desalination systems the product will increase system run lengths.Handling Avoid contact with skin and eyes. In case of contact, flush with water for few minutes. Remove contaminated clothing and launder before re-use.Storage The product should be stored with their seals intact, in conditions that avoid extreme temperature. Under the above conditions the shelf life of the product would be approx. 2 yrs.Packaging Cool Solv SRWT-1121 is available in 30/50 litre HDPE jerricans/barrels.Product Cool Solv SRWT-1121 can be supplied on request from Dorf Ketal’sAvailability manufacturing site at Taloja near Mumbai. For details contact Dorf Ketal’s marketing department.
COMPANY PROFILE:Dorf Ketal – a leader in Speciality Chemicals needed for oil exploration; refining & petrochemicalprocess applications formed its water treatment & fuel additives division in 2001 in collaborationwith Chemtreat, USA.Company has following quality certifications ISO 14001:1996 OHSAS 18001:1999 ISO 9001:2000 Frost & Sulivan Award 2005 Emerging India Award.With its state-of-the-art manufacturing, R&D and analytical facility in Taloja near Mumbai and ateam of qualified engineers. Dorf Ketal can provide solutions for any water treatment problems.Dorf Ketal’s WTC division has cutting age technologies which encompasses following areas: -. Technical / Troubleshooting support for various industrial applications. Classroom & on site Training programs. Joint visits with our Agents/Dealers whenever needed to ensure that customers get maximum benefit from the water treatment programs. Trailer made programs for specific industrial applications. Providing various monitoring tool for various water treatment applications.
OUR APPLICATION AREADorf Ketal has products to solve any kind of problem related to Cooling and Boiler water system.We recently developed products in our fuel additive division for different fuel application. Cooling Water System:Generally there are three major problems encountered in an industrial cooling water system, vizCorrosion, Scaling and Microbiological growth. Each of these require specialized chemicals tominimize the effect on plant performance and improve productivity. Please find below a briefdescription of the individual cooling water product applications; Corrosion Inhibitors:These are multifunctional products mainly used for control of both corrosion and scaling in anIndustrial cooling water system. It contains organo-phosphate, ortho-phosphate, poly phosphate,zinc, molybdate with the combination of powerful dispersant depending upon the application. Polymers:Dorf Ketal has a wide range of polymers in its product range. These are useful in controllingscale and deposition in applications where the cooling water has high hardness, high TDS level& high heat load. Dispersants also help in dispersing suspended particles, minerals salts andorganic materials.
Non Oxidizing Biocides:We have Broad spectrum biocides to control microbial species like, bacteria, fungi, and algae bydifferent mechanisms. Our product range consists of various chemistries like, Isothiazolene,Quarternary Ammonium compounds, TBTO, DBNPA, Bronopol, Carbamate etc., based biocides. Boiler Water System:Industrial boiler water systems mainly encounter problems due to oxygen pitting, scaling andcorrosion. These if uncontrolled can cause rapid failure of boiler tubes which in turn lead toequipment failure, loss of production and energy losses. Which would result in reduced boilerefficiency and increased downtime. Dorf Ketal Products:Dorf Ketal has developed products to protect the completeboiler water system from oxygen related corrosion, scalingand deposition. We have a whole range of oxygen scavengersfrom Catalyzed sulfite, Hydrazine and DEHA which canprotect the boiler water system from oxygen pitting. Thesecan be applicable for low, medium as well as high pressureboilers. We also have pH boosters and neutralizingamines/Filming amines are available to prevent corrosiondue to low pH in condensate line.
Antiscalant for R.O. System: Dorf Ketal has developed a comprehensive product in R.O.application. It is a polymer based product mainly used to prevent membrane fouling from deposit forming species and increase plant run length and hence increase membrane life by reducing cleaning frequency. Thermal Desalination :Dorf Ketal has developed a next generation antiscalant to maintain aid in ThermalDesalination operations. Some of the product benefits are given below, Prevents the formation of typical evaporator scale. Effectively controls carbonate as well as sulphate scale formation in a multistage thermal distillation process. It is NSF approved for use upto 10 ppm. It has higher dispersing ability for mud, suspended matter and silt. Highly effective in sea water, brackish water and bad quality bore well water. It is multifunctional and can disperse calcium salts and iron oxides much more effectively at high temperatures as compared to standard products and hence will maintain cleaner heat transfer surfaces by better and more effective dispersion mechanism.
Fuel Additives:In Fuel Additive segment we have various ranges of products which can be used in fuels likeHSD, LSHS, LDO, FO, Coal etc. The main properties are present in our different types of fueladditives are Dispersant, Fuel Stabilizer, Combustion Catalyst, Deposits & Corrosion Inhibitor,Cetane & Lubricity Improver. OCCUPATIONAL HEALTH, SAFETY & ENVIRONMENT POLICY DORF KETAL CHEMICALS (I) PVT. LTD., manufacturers of Specialty Chemicals for industrial & potable applications, attaches the highest priority in its business to the promotion of Health, Safety and Environment. We shall therefore set, as far as possible, SMART objectives and endeavor to: Provide a healthy and safe environment to our employees. Minimize pollution and make optimum utilization of natural resources. Implement, maintain and ensure continual improvement of the HSE Performance. Increase the level of awareness and competency of our employees in handling HSE issues. Inculcate a feeling of ownership amongst employees towards HSE issues.
SERVICES OFFERED Corrosion Studies as per internal standards. Microbial facility to identify microbes and determine minimum inhibitory biocide concentration. Test kits to conduct routine water analysis Heat exchanger simulating units· Performance evaluation test heat exchangers. Water conservation studies. Joint meeting with the customer to review the treatment program. Heat exchanger inspection & expert recommendations. Scale & Deposit analysis & recommendations. INDUSTRIAL EXPERIENCEDorf Ketal’s WTC division has no. of success stories to its credit within a short span of 5 years, some ofthese are listed below, We have successfully treated major power plants across India. Our antiscalant has been successfully applied at Asia’s largest Sea Water Desalination unit (capacity 2000 m3/hr Desal water capacity) We have been successful in providing cooling water treatment program for a refinery cooling water system for more than 2 years. We have experience of providing total water management for a steel complex in India. We have provided chemicals for Boiler Water treatment applications for various capacity boilers. We have a wide agency network already placed across India. We have complete range of products to solve various water treatment applications like, cooling water, boiler water, waste water, thermal desalination, & RO chemicals. We have trained representatives all across India to handle customer issues and provide solutions to water treatment problems.
MATERIAL SAFETY DATA SHEETSection 1. Chemical Product and Company IdentificationProduct NameSRWT-1121Manufacturer’s Name Emergency Telephone NumberDorf Ketal Chemicals (I) Pvt. Ltd. 91- 22- 28880420 Fax Number 91 –22 -28813655Address (Number, Street, City, State, and ZIP Code) Telephone Number For InformationCorporate Headquarters: #1, Dorf Ketal Tower, 91-22-28443903 D’Monte Street, Orlem, Malad (West), Mumbai 400 064. India.Manufacturing Location: W-165 (B) & I-10/3, Emergency Telephone : 91-22-27410466 MIDC Taloja, Telefax No.: 91-22- 27410466 Raigad District, Date Prepared: 11th June, 2003 Maharashtra, IndiaSection 2. Composition / Information on Ingredients Component CAS Registry # Wt. %Polymers Proprietory –Phosphonates Proprietory –Section 3. Hazards IdentificationEMERGENCY OVERVIEW:Yellow to light straw, clear liquid; mild odor. May irritate eyes & skin. Not flammable.POTENTIAL HEALTH EFFECTS:EYE CONTACT:Can cause slight eye irritation.INHALATION:May cause irritation of nose throat lungs headache nausea if inhaled.SKIN CONTACT:Prolonged or repeated skin contact may cause slight skin irritation.INGESTION:Nausea and vomiting may occur. Low order or toxicity.CHRONIC EFFECTS / CARCINOGENICITY:No information found on significant long-term effects.TARGET ORGANS:Eyes, Skin.Section 4. First Aid MeasuresINHALATION:Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get immediatemedical attention.EYE CONTACT:Immediately flush eyes with plenty of water. Get immediate medical attention if irritation persistsSKIN CONTACT:Wash with soap and water. Get medical attention if irritation develops or persists.INGESTION:If swallowed, induce vomiting immediately as directed by medical personnel. Never give anything by mouth to anunconscious person. Get medical attention immediately.
Section 5. Fire Fighting MeasuresFLAMMABLE PROPERTIES:FLASH POINT: Not inflammable METHOD USED: NAFLAMMABLE LIMITS:LFL NA UFL: NA FIRE & EXPLOSION HAZARDS: As in any fire, wear self-contained breathing apparatus, pressure-demand, MSHA/NIOSH approved or equivalent, and full protective gear. Use extinguishing media appropriate to surrounding fire.Section 6. Accidental Release MeasuresContain spill with dike to prevent entry into waterways. Place spilled materials in containers for disposal. Flushspilled area with water. All cleanup material should be removed for proper treatment or disposal.Section 7. Handling and StorageWash thoroughly after handling. Remove contaminated clothing and wash before reuse.Use only in a well ventilated area. Avoid contact with eyes, skin and clothing.Minimum recommended storage temperature for this material is 1 oC/34oF.The maximum recommended storage temperature for this material is 49oC/120oF.Section 8. Exposure Controls / Personal ProtectionGood general ventilation should be sufficient to control airborne levels. Wear chemical safety goggles plus full-faceshield to protect against splashing when appropriate (ANSI Z87.1). Wear chemical resistant gloves, such as rubber,neoprene, or vinyl. Wear chemically resistant apron or other impervious clothing appropriate to the situation inorder to avoid contact with the product, such as impervious boots, overalls, apron, full suits. Facilities storing orutilizing this material should be equipped with an eyewash facility and a safety shower.Section 9. Physical and Chemical PropertiesAPPEARANCE: Yellow to brownish, clear PHYSICAL STATE: LiquidBOILING RANGE: ~104oC SOLUBILITY IN WATER: CompleteEVAPORATION RATE: As water SPECIFIC GRAVITY: ~1.27FREEZING POINT: N/A VAPOR DENSITY: Same as waterMELTING POINT: N/A VAPOR PRESSURE Same as waterODOR: Mild VISCOSITY: N/ApH: 11.0 – 11.5 % VOLATILE: 60 – 70 (water)FLASH POINT (OPEN CUP) 93oCSection 10. Stability and ReactivityCHEMICAL STABILITY: Stable at normal temperatures and pressureINCOMPATIBILITY: Substance, which react with water.HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition will produce oxides of carbon & nitrogen.HAZARDOUS POLYMERIZATION: Will not polymerize.Section 11. Toxicological InformationLow toxicitySection 12. Ecological InformationNot tested.Section 13. Disposal ConsiderationsDispose of in accordance with federal, state and local regulations.Section 14. Transport Information (Not meant to be all inclusive)D.O.T. SHIPPING NAME: Not D.O.T. RegulatedSection 15. Regulatory Information (Not meant to be all inclusive - selected regulation represented)CERCLA REPORTABLE QUANTITY: NoneSARA TITLE III: None SECTION 302 EXTREMELY HAZARDOUS SUBSTANCES: None SECTION 313 TOXIC CHEMICALS:CALIFORNIA PROPOSITION 65: No
Section 16. Other Information Hazard Ratings Health 1 Flammability 0 Reactivity 0 SARA Hazard Categories Section 311/312: Acute Yes Chronic No Fire No Reactive No Sudden Release NoAlthough the information and recommendations set forth herein (hereinafter “Information”) are presentedin good faith and believed to be correct as of the date hereof, Dorf Ketal makes no representations as to thecompleteness or accuracy thereof. Information is supplied upon the condition that the persons receivingsame will make their own determination as to its suitability for their purposes prior to use. In no event willDorf Ketal be responsible for damages of any nature whatsoever resulting from the use or reliance uponInformation. NO REPRESENTATION OR WARRANTIES, EITHER EXPRESS OR IMPLIED, OFMERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR OF ANY OTHER NATUREARE MADE HEREUNDER WITH RESPECT TO INFORMATION OR THE PRODUCT TO WHICHINFORMATION REFERS.