Upcoming SlideShare
×

Digital Communications Jntu Model Paper{Www.Studentyogi.Com}

1,893 views
1,861 views

Published on

Digital Communications Jntu Model Paper{Www.Studentyogi.Com}

1 Comment
0 Likes
Statistics
Notes
• Full Name
Comment goes here.

Are you sure you want to Yes No
• pls send a solution for the above question paper

Are you sure you want to  Yes  No
• Be the first to like this

Views
Total views
1,893
On SlideShare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
43
1
Likes
0
Embeds 0
No embeds

No notes for slide

Digital Communications Jntu Model Paper{Www.Studentyogi.Com}

1. 1. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 1 III B.Tech I Semester Regular Examinations, November 2007 DIGITAL COMMUNICATIONS ( Common to Electronics & Communication Engineering and Electronics & Telematics) Time: 3 hours Max Marks: 80 Answer any FIVE Questions All Questions carry equal marks 1. The threshold value of the input signal power to noise ratio ( )i in PCM system is de ned as the value of ( )i for which the value of (S/N)o is 1dB below its maximum. (a) Show that the threshold occurs when e ˜ 1 [16(22N )] (b) Plot e Versus N, for N = 2, 4, 6 and 8. (c) Sketch the threshold values of ( )i Versus N for which N = 2, 4, 6 and 8 (Assume that a PSK signaling scheme is used) [6+5+5] 2. (a) What is Delta modulation and compare with PCM? (b) Discuss di erent types of noise e ects in delta modulation. [8+8] 3. (a) Write down the modulation waveform for transmitting binary information over base band channels, for the following modulation schemes: ASK, PSK, FSK and DPSK. (b) What are the advantages and disadvantages of digital modulation schemes? (c) Discuss base band transmission of M-ary data. [4+6+6] 4. (a) Explain how the residual e ects of the channel are responsible for ISI? (b) What is the practical solution to obtain zero ISI? Explain. [8+8] 5. (a) De ne Information rate. (b) One of four possible messages Q1, Q2, Q3, Q4 having probabilities 1/8, 3/8, 3/8 and 1/8 respectively is transmitted. Calculate average Information per message. [16] 6. An Ideal channel lowpass channel of bandwidth B Hz with additive Gaussian white noise is used for transmitting of digital information. (a) Plot C/B versus S/N in dB for an Ideal System using this channel. (b) A practical signaling scheme on this channel uses one of two waveforms of duration Tb sec to transmit binary information. The signaling scheme transmits data at the rate of 2B bits/sec, the probability of error is given by P(error|1sent) =Pe. Plot graphs of
2. 2. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 1 ii. Dt / B. where Dt is rate of information transmission over channel. [16] 7. Explain about blo ck codes in which each block of k message bits enco ded into block of n k bits with an example. [16] 8. Explain various methods for describing Conventional Codes. [16]
3. 3. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 2 III B.Tech I Semester Regular Examinations, November 2007 DIGITAL COMMUNICATIONS ( Common to Electronics & Communication Engineering and Electronics & Telematics) Time: 3 hours Max Marks: 80 Answer any FIVE Questions All Questions carry equal marks 1. (a) Derive the relation for signaling rate and transmission bandwidth in a PCM system. (b) Explain the terms: i. Quantization noise in a PCM ii. Nyquist rate & Nyquist interval [8+4+4] 2. (a) Write short notes on i. Granular Noise ii. Slope overload distortion. (b) Derive an expression for quantization noise in Delta modulation. [8+8] 3. (a) A binary base band is passed through a raised cosine roll - o lter with a 50% roll - o factor and is then modulated on to a carrier. The data rate is 64kbits/sec. Evaluate i. The absolute bandwidth of a resulting ASK signal. ii. The approximate bandwidth of a resulting FSK signal when the mark frequency is 150kHz and the space frequency is 155kHz. (b) Write the comparisons among binary mo dulated band pass signaling scheme (ASK, PSK and FSK). [10+6] 4. (a) What is meant by ISI? Explain how it di ers from cross talk in the PAM. (b) What is the ideal solution to obtain zero ISI and what is the disadvantage of this solution. [6+10] 5. De ne and explain the following in terms of joint pdf p(x, y) and marginal pdf’s p(x) and p(y). (a) Mutual Information. (b) Average Mutual Information. (c) Entropy. [16] 6. (a) Calculate the bandwidth limits of Shannon-Hartley theorem. (b) What is an Ideal system? What kind of method is proposed by Shannon for an Ideal system? [16]
4. 4. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 2 7. Let H be the parity check matrix of (n-k) linear block code C with an o dd minimum weight d. Construct a new code C1 whose parity check matrix is [16] |0 |0 |0 | 1= | | |0 - - - - - |- - - 11 1 |1 Show that (a) every code vector in C1 has not o dd weight. (b) the minimum weight of C1 is d+1. [16] 8. Explain various methods for describing Conventional Codes. [16]
5. 5. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 3 III B.Tech I Semester Regular Examinations, November 2007 DIGITAL COMMUNICATIONS ( Common to Electronics & Communication Engineering and Electronics & Telematics) Time: 3 hours Max Marks: 80 Answer any FIVE Questions All Questions carry equal marks 1. The speci cations of a PCM signal of a digital telephone system is as follows: Audio voice frequency : 300Hz to 3400Hz Sampling frequency : 8k samples/sec. And each sample is represented by 8 bits. Then nd (a) Bit rate, the rst null bandwidth and Signal power to quantization power ratio (b) Minimum bandwidth required if i. Sinc pulse is used to generate PCM ii. Rectangular pulse shaping is used [16] 2. (a) Compare Delta modulation and PCM techniques in terms of bandwidth and signal to noise ratio. (b) A signal m(t) is to be encoded using either Delta modulation or PCM tech- nique. The signal to quantization noise ratio ( O O) = 30dB. Find the ratio bandwidth required for PCM to Delta Modulation. [8+8] 3. (a) Explain the signal space representation of QPSK. (b) Compare QPSK with all other digital signaling schemes. [8+8] 4. (a) Derive an expression for error probability of coherent ASK scheme. (b) Binary data has to be transmitted over a telephone link that has a usable bandwidth of 3000Hz and a maximum achievable SNR of 6dB at its output i. Determine the maximum singling rate and error probability if a coherent ASK scheme is used for transmitting binary data through this channel. ii. If the data rate is maintained at 300 bits/sec. calculate the error proba- bility. [8+8] 5. Let X is a discrete random variable with equally probable outcomes x1=A, and x2=- A and conditional probability pdf’s p(y/xi), i=1, 2 be the Gaussian with mean xi and variance 2. Calculate average mutual information I(X; Y). [16] 6. A Binary Symmetric channel is shown in gure 6.
6. 6. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 3 Figure 6 Find the rate of information transmission over this channel when p= 0.9, 0.8 and 0.6. Assume that the symbol rate (or bit) is 1000/sec. [16] 7. Explain about blo ck codes in which each block of k message bits enco ded into block of n k bits with an example. [16] 8. Explain various methods for describing Conventional Codes. [16]
7. 7. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 4 III B.Tech I Semester Regular Examinations, November 2007 DIGITAL COMMUNICATIONS ( Common to Electronics & Communication Engineering and Electronics & Telematics) Time: 3 hours Max Marks: 80 Answer any FIVE Questions All Questions carry equal marks 1. A signal m(t) band limited to 4kHz is sampled at twice the Nyquist rate and the samples transmitted by PCM. An output SNR of 47dB is required. (a) Find N and minimum value of i if operation is to be above threshold. (b) Calculate minimum system bandwidth required and nd signaling rate needed to achieve the given output SNR. [4+4+4+4] 2. (a) What is Delta modulation and compare with PCM? (b) Discuss di erent types of noise e ects in delta modulation. [8+8] 3. (a) Explain the signal space representation of QPSK. (b) Compare QPSK with all other digital signaling schemes. [8+8] 4. (a) Derive an expression for error probability of non - coherent ASK scheme. (b) Binary data is transmitted over an RF band pass channel with a usable band- width of 10MHz at a rate of 4,8 × 106 bits/sec using an ASK singling method. The carrier amplitude at the receiver antenna is 1mV and the noise power spectral density at the receiver input is 10-15w/Hz. i. Find the error probability of a coherent receiver. ii. Find the error probability of a coherent receiver. [8+8] 5. Write short notes on the following: (a) Mutual Information. (b) Self Information. (c) Logarithmic measure for information. [16] 6. (a) De ne the channel capacity in terms of average signal-power and noise power. (b) Mention the two important implications of Shannon-Hartley theorem? [16] 7. Consider a (6, 3) generator matrix. 1 0 0| 0 1 1 = 0 1 0| 1 0 1 0 0 1| 1 1 0 Find
8. 8. www.studentyogi.com www.studentyogi.com Code No: R05310404 Set No. 4 (b) the parity check matrix for this code. (c) the minimum weight of this code. [16] 8. Explain various methods for describing Conventional Codes. [16]