• Save
Clutch Plate Modelling And Analysis
Upcoming SlideShare
Loading in...5
×
 

Like this? Share it with your network

Share

Clutch Plate Modelling And Analysis

on

  • 2,425 views

 

Statistics

Views

Total Views
2,425
Views on SlideShare
2,423
Embed Views
2

Actions

Likes
1
Downloads
0
Comments
0

1 Embed 2

http://www.linkedin.com 2

Accessibility

Categories

Upload Details

Uploaded via as Microsoft PowerPoint

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

Clutch Plate Modelling And Analysis Presentation Transcript

  • 1. MAE 477/577Final Project Poster Presentation
    -Shreeganesh Sudhindra
    &
    Qaiser.J.Khan
  • 2. Project Description
    Objective :
    To model a Single Dry Clutch Plate assembly
    To perform the Structural Analysis of the Contact Surfaces (Fly Wheel and Clutch Plate)
    To perform a modal analysis of the Clutch Plate (Natural Frequencies and Mode Shapes)
  • 3. Model Assembly
  • 4. Exploded View
  • 5. Cross Sectional View
  • 6. Structural Analysis
    Objective
    To calculate the total deformation, Von-Misses stress, frictional stress and pressure experienced on the contact region.
    To mesh the components and apply the loads.
    Perform a Mesh convergence study.
  • 7.
  • 8. Model the contact region between clutch plate and the fly wheel
  • 9. Mesh For academic reasons a free mesh with constant strain triangular elements was used although it is not advisable to do so.
  • 10. Constraints and Loads
  • 11. Results
  • 12. Results (Continued)
  • 13. Mesh Refinement Studies
  • 14. Conclusion
    ProE software package was used to model the entire assembly.
    Ansys Work Bench was used to perform the above mentioned analysis successfully.
    The maximum stresses of the assembly were found to be well within yield limits for the given loads and material properties.
    In this project the capabilities of Pro Engineer and Ansys Work Bench software package was explored.