STARTING WITH A STOCK CART <ul><li>2004 E-Z-GO PDS </li></ul>
WE REMOVE THE BODY <ul><li>Removing the body exposes the chassis and in this case the batteries and the entire electrical system. </li></ul>
SYSTEM INSPECTION <ul><li>Whether it be an electric cart or gas cart, the entire system is gone through. </li></ul>
ELECTRIC CART INSPECTION <ul><li>The batteries are load tested and cleaned. The electrical system on the cart, which includes cables, micro switches, motor, solenoid and controller is tested and inspected for excess wear or damaged and is replaced if necessary. </li></ul>
GAS CART INSPECTION <ul><li>All belts and moving parts are inspected for wear and replaced if necessary. Also all fluids and filters are changed. We also readjust the valves and replace the spark plugs to insure proper operation of the cart. </li></ul>
FINAL INSPECTION <ul><li>After the cart is inspected, washed, painted and re-inspected. It is brought inside the shop for a final inspection to insure it is ready to be built. </li></ul>
FURTHER INSPECTION <ul><li>After the initial inspection is completed the cart is raised and pressure washed to check for any structural damage or rust. If any is present the part is either repaired or replaced. The entire chassis is then repainted. </li></ul>
PREPPING TO BUILD <ul><li>The batteries are put back in the cart, if good, replaced if necessary or the motor is cleaned and serviced. </li></ul>
BUILDING THE CART <ul><li>In this case the cart is receiving a painted body. The body is put on and all plastic pieces and replaced if necessary. </li></ul>
Completion <ul><li>Upon completion the cart is inspected once more to insure that all steps were taken to put out the best product possible. </li></ul>
FAT BOY’S GOLF CARTS 10445 OLD ATLANTA HWY COVINGTON GA 30014 WWW.FATBOYSCARTS.COM 678-625-0711
A particular slide catching your eye?
Clipping is a handy way to collect important slides you want to go back to later.