• Save
Internet of thing: Trabajando con Arduino y Visual Studio
Upcoming SlideShare
Loading in...5
×
 

Internet of thing: Trabajando con Arduino y Visual Studio

on

  • 2,429 views

Slides de la sesión de introducción a Arduino y Visual Studio para MSDN Latinoamérica

Slides de la sesión de introducción a Arduino y Visual Studio para MSDN Latinoamérica

Statistics

Views

Total Views
2,429
Slideshare-icon Views on SlideShare
782
Embed Views
1,647

Actions

Likes
3
Downloads
0
Comments
0

15 Embeds 1,647

http://geeks.ms 1063
http://elbruno.com 445
http://feedly.com 60
http://darmstadt3.rssing.com 49
http://labloguera.net 14
http://feeds2.feedburner.com 4
http://inoreader.com 2
http://131.253.14.66 2
http://reader.aol.com 2
http://feeds.feedburner.com 1
http://joansafr.tumblr.com 1
http://131.253.14.98 1
http://www.feedspot.com 1
http://cloud.feedly.com 1
http://digg.com 1
More...

Accessibility

Categories

Upload Details

Uploaded via as Microsoft PowerPoint

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

    Internet of thing: Trabajando con Arduino y Visual Studio Internet of thing: Trabajando con Arduino y Visual Studio Presentation Transcript

    • Bruno Capuano Innovation Manager @elbruno http://www.elbruno.co m
    • $30 Investment!
    • Specification Clock Speed 16MHz 32K EEPROM • Component Flash Memory • 1K SRAM 2K Analog -> Digital 6Ch 10bit Communication SPI Digital 14 I/O PWM 6 Channel (Digital)
    • Digital Pins USB Connector Battery Connector Power Pins Analog Pins
    • • • • Circuit on breadboard
    • • Ejemplo void setup void loop
    • start void setup() { //code1 //code2 } void loop() { //code3 //code4 //code5 } code1 code2 code3 code4 code5
    • start void setup() { >configure output pin >Led is OFF } void loop() { >LED is ON >Time delay >LED is ON >Time Delay } Configure Output pin LED is off LED is on Time delay LED is off Time delay
    • int LED1Pin = 7; void setup() { pinMode(LED1Pin, OUTPUT); digitalWrite(LED1Pin, LOW); } void loop() { digitalWrite(LED1Pin, HIGH); delay(500); digitalWrite(LED1Pin, LOW); delay(250); } //Pin 7 is output pin //LED is initially low //Turn on LED. //Time delay for 0.5 second. //Turn off LED. //Time delay for 0.25 second.
    • Verify button
    • Note: Make sure USB-to-serial driver is installed first
    • Upload button
    • Ethernet Servo/Stepper/ DC Motors Prototypin g GPS Audio / MP3
    • LCD MIDI LED Display Zigbee WIFI
    • http://elbruno.com/category/informatica-e-internet/arduino/ http://arduino.cc http://arduino.cc/downloads http://arduino.cc/en/Main/Software#toc3 http://www.visualmicro.com http://visualmicro.codeplex.com/ http://www.visualmicro.com/archive.aspx http://www.seeedstudio.com/depot/grove-t-3.html?ref=top