How to publish your
paper in international
journals
Boonsap Witchayangkoon, PhD
Executive Editor
@ TuEngr.com
The right scientific journals for quality work::
•American Transactions on Engineering &
Applied Sciences (ATEAS)
• Intern...
Originality
•Your work must not have been
previously published
•Your work must not have been
submitted to other publisher ...
Publish or Perish
•Effective presentation of your work
•Write clearly
– Clean & clear writing
•Discuss critical aspects
•H...
•All submitted manuscripts will be
reviewed independently by three
individuals who have an
understanding and appreciation ...
Peer Review
•Peer-review process (4-10 Weeks)
•Editor cannot guarantee the exact
publication time as the process may
take ...
Units
•SI system of units is preferable.
Dr.Boonsap Witchayangkoon
Figure and Table
•All figure and table must be
mentioned in writing, by referring to
each figure/table.
•example:
–All coe...
Figure and Table
•Use clear graphic
•Modern journals – place Figure /
Table near where it is mentioned.
Dr.Boonsap Witchay...
Length of Manuscript
•Shortest is the most preferable.
•So be specific/focus on the topic
Dr.Boonsap Witchayangkoon
• The nomenclature section should be
inserted between the abstract and the
introduction.
• Symbols is listed in alphabetic...
References
•New up-to-date information should
be used, authors should cite newest
references sources as possible.
•Importa...
Plagiarism – Ethical Aspects
Whole or partial imitation(s) of previous
works as your own original works are
considered pla...
Malpractice statement
•Plagiarism (& self-plagiarism) is
checked before a manuscript
gets published. If plagiarism is
dete...
Malpractice statement
• If plagiarism of a published article is found,
Editor or Editorial Board Member(s) will
officially...
Editorial Policy
• Papers of research reports and articles
with scientific research merit will be
judged for publication u...
Editorial Policy
•The editor reserves the right to
recommend for revision as a
condition for final acceptance.
Open-Access E-Journals
•Entirely unrestricted access
•UK Wellcome Trust:: “the benefits of
research are derived principall...
•Unrestricted reuse
– Licensees may copy, distribute,
display and perform the work and
make derivative works based on it
o...
Open-Access E-Journals
•Quick publication process
•Highly reach to wide audiences
•Get higher citation rate
•Research gran...
ACCEPTANCE VS REJECTION
•Carefully read the review result
•Accept: “Lucky you for the great job"
•Accept with revision: “L...
Take a chance to learn
•Believe in high quality work
•Do not fear
•Do not panic
•No angry: more rejections,
more experienc...
PUT IN TEMPLATE
& TURN IT IN
TuEngr.com
MIT Libraries, USA
Standford University Library, USA
THANK YOU
TuEngr.com
American Transactions on
Engineering & Applied
Sciences
International Transaction Journal
of Engineer...
Upcoming SlideShare
Loading in …5
×

How to publish your paper in international journals

753 views
699 views

Published on

scientific and engineering e-journal publication TuEngr.com group. International Transaction Journal of Engineering, Management, & Applied Sc iences & Technologies publishes wide spectrum research and technical articles as well as reviews, experiments, experiences, modelings, simulations, designs, and innovations from engineering, sciences, life sciences, and related disciplines as well as interdisciplinary/cross-disciplinary/multidisciplinary subjects. Original work is required. Article submitted must not be under consideration of other publisher for publications.

Published in: Technology, Education
0 Comments
1 Like
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total views
753
On SlideShare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
44
Comments
0
Likes
1
Embeds 0
No embeds

No notes for slide

How to publish your paper in international journals

  1. 1. How to publish your paper in international journals Boonsap Witchayangkoon, PhD Executive Editor @ TuEngr.com
  2. 2. The right scientific journals for quality work:: •American Transactions on Engineering & Applied Sciences (ATEAS) • International Transaction Journal of Engineering, Management, & Applied Sciences & Technologies (ITJEMAST) Focused as eJournalsDr.Boonsap Witchayangkoon
  3. 3. Originality •Your work must not have been previously published •Your work must not have been submitted to other publisher at the same time •Sign copyright transfer (with emails of all authors) Dr.Boonsap Witchayangkoon
  4. 4. Publish or Perish •Effective presentation of your work •Write clearly – Clean & clear writing •Discuss critical aspects •Helps from colleagues to read/check – One from the same research field – One from other research field Dr.Boonsap Witchayangkoon
  5. 5. •All submitted manuscripts will be reviewed independently by three individuals who have an understanding and appreciation of the academic peer review process and the respective standards. •The majority of reviewers must recommend for publication. A successful peer review note is added to the end of the published article. Peer Review: Dr.Boonsap Witchayangkoon
  6. 6. Peer Review •Peer-review process (4-10 Weeks) •Editor cannot guarantee the exact publication time as the process may take longer time, subject to peer- review approval and adjustment of the submitted articles. Dr.Boonsap Witchayangkoon
  7. 7. Units •SI system of units is preferable. Dr.Boonsap Witchayangkoon
  8. 8. Figure and Table •All figure and table must be mentioned in writing, by referring to each figure/table. •example: –All coefficients in Table 5 are from simulation. •Do not use "the above Table" or "the Figure below." Dr.Boonsap Witchayangkoon
  9. 9. Figure and Table •Use clear graphic •Modern journals – place Figure / Table near where it is mentioned. Dr.Boonsap Witchayangkoon
  10. 10. Length of Manuscript •Shortest is the most preferable. •So be specific/focus on the topic Dr.Boonsap Witchayangkoon
  11. 11. • The nomenclature section should be inserted between the abstract and the introduction. • Symbols is listed in alphabetical order within each of the following groups: English group first, then Greek, subscripts, and superscripts. Numbers and other symbols should be listed last. • If the nomenclature section exists, no need to give definitions scattered throughout the text. • Acronyms is defined in the text, not in the nomenclature. Nomenclature and Symbols Dr.Boonsap Witchayangkoon
  12. 12. References •New up-to-date information should be used, authors should cite newest references sources as possible. •Important  All references must be mentioned in the writing, and vice versa. •Make sure all references are correct. •Only references are used, not bibliography, not footnote. Dr.Boonsap Witchayangkoon
  13. 13. Plagiarism – Ethical Aspects Whole or partial imitation(s) of previous works as your own original works are considered plagiarism, especially through cut and paste process – to have multiple work(s) published in multiple publications when little / no new information / knowledge is added. Author(s) who reuse(s) substantial parts of their own published work without providing the appropriate references is considered self- plagiarism. Dr.Boonsap Witchayangkoon
  14. 14. Malpractice statement •Plagiarism (& self-plagiarism) is checked before a manuscript gets published. If plagiarism is detected, the manuscript will be rejected and the author(s) is(are) put on the blacklist. Dr.Boonsap Witchayangkoon
  15. 15. Malpractice statement • If plagiarism of a published article is found, Editor or Editorial Board Member(s) will officially contact the authors' institute(s) and funding agencies, informing such academic misconducts. • Plagiarism note with online (multiple) link(s) to same elsewhere published article(s) or plagiarized material(s) is explicitly displayed. Either clear plagiarism mark(s) will be added to the published article(s) or plagiarized article(s) is(are) retracted. Dr.Boonsap Witchayangkoon
  16. 16. Editorial Policy • Papers of research reports and articles with scientific research merit will be judged for publication under careful consideration from international reviewers. Such research reports and articles include those containing substantial supported theories, innovative works, substantial experimental results and/or containing useful and constructive discussions or reviews standardized to regional or international acceptance. Dr.Boonsap Witchayangkoon
  17. 17. Editorial Policy •The editor reserves the right to recommend for revision as a condition for final acceptance.
  18. 18. Open-Access E-Journals •Entirely unrestricted access •UK Wellcome Trust:: “the benefits of research are derived principally from access to research results” •Free to read / save / distribute Dr.Boonsap Witchayangkoon
  19. 19. •Unrestricted reuse – Licensees may copy, distribute, display and perform the work and make derivative works based on it only if they give the author or licensor the credits in the manner specified by these. Open-Access E-Journals Attribution (by) Dr.Boonsap Witchayangkoon
  20. 20. Open-Access E-Journals •Quick publication process •Highly reach to wide audiences •Get higher citation rate •Research grant helps paying small publication fee
  21. 21. ACCEPTANCE VS REJECTION •Carefully read the review result •Accept: “Lucky you for the great job" •Accept with revision: “Let’s do some minor improvements." •Revise and resubmit: “Your work still get some attention!" •Reject and resubmit: “The Editor still want your paper!" Dr.Boonsap Witchayangkoon
  22. 22. Take a chance to learn •Believe in high quality work •Do not fear •Do not panic •No angry: more rejections, more experiences Dr.Boonsap Witchayangkoon
  23. 23. PUT IN TEMPLATE & TURN IT IN TuEngr.com MIT Libraries, USA Standford University Library, USA
  24. 24. THANK YOU TuEngr.com American Transactions on Engineering & Applied Sciences International Transaction Journal of Engineering, Management, & Applied Sciences & Technologies Dr.Boonsap Witchayangkoon

×