Sprocket side stand retrieve system ppt

15,872
-1

Published on

Sprocket side stand retrieve system

Published in: Education
1 Comment
15 Likes
Statistics
Notes
No Downloads
Views
Total Views
15,872
On Slideshare
0
From Embeds
0
Number of Embeds
3
Actions
Shares
0
Downloads
825
Comments
1
Likes
15
Embeds 0
No embeds

No notes for slide

Sprocket side stand retrieve system ppt

  1. 1. SPROCKET SIDE-STAND RETRIEVE SYSTEM INTRODUCTION In modern world the living status were developed and developing more equipped. The automobile takes a great part in the development, since it plays one of a major key in daily life. while automobile is concern two-wheeler i.e(motorcycles and bike) it plays very important role because it saves the time of traveler by reaching the target place very faster. Although it saves the time it does not safe the life of rider if rider is careless.
  2. 2. SOURCE FOR ACCIDENTS• While the two-wheelers is concerned accidents occurs due to riding the vehicle inhigh speed, ignores to use helmets, does not maintains the speed limit and forgetsto lift the side stand while riding the vehicles. These are the major source foraccidents.•Forgetting to lift the side stand causes huge accidents in rural areas partly inurban areas too, but accident due to side stand do not have proper preventivemeasure. If you see the accident status 36% of the accidents occur due to thisproblem. S.NO DURING THE YEAR REASON FOR THE ACCIDENT %OF ACCIDENTS 1. 2008-2012 Forgetting to lift side-stand 36% 2. 2008-2012 Does not maintain speed limit 38% 3. 2008-2012 Does not obey traffic rules 22% 4. 2008-2012 Other problems 04%
  3. 3. PROPOSED METHODSPROCKET SIDE-STAND RETRIEVE SYSTEMBased on the working principle of two-wheeler ( i.e the power is generated in theengine and it transmits power to the pinion and makes it to rotate. The pinion transmitspower to the rear wheel pinion and makes the vehicle to move).This is the basic principle followed in all type of two-wheelers, based on this“SPROCKET SIDE STAND RETRIVAL SYSTEM” is designed because this system works bygetting power from chain drive. This sprocket system consists of four componentsAxleSprocket pinionLifting leverPushing lever
  4. 4. axle with key waySprocket with bearing
  5. 5. Lifting lever Pushing lever
  6. 6. WORKING PROCESS Sprocket side stand retrieve system retrieves the side stand automatically if the riderforgets to lift the side stand while moving the bike. It works based on the working principleof the two-wheelers.Every bikes transmit power from engine’s pinion to the rear wheel i.e. rotary motion ofthe pinion makes the linear motion of the chain. that linear motion of the chain is absorbedby rear wheel’s sprocket and converted into rotary motion.That rotary motion of the rear wheel makes the bikes to move. Based on this Sprocketside stand retrieve system is designed.
  7. 7.  AT RESTING CONDITION
  8. 8. RETRIVEL CONDITION
  9. 9.  RETRIVED CONDITION
  10. 10. CONCLUSION “ Sprocket- side stand retrieve system” will definitely good retrieve system. since thesetup is compact it does not affect the performance of the vehicle. because of the power isobtained from chain drive.Definitely this system could be used in all type of two-wheelers (Tvs-XL, all front, back,hand geared) for retrieving the side stand.These system can be implemented in all types of bikes by changing small variation in sizeand cost of this system also very low and so it will not affect the economic level also, whilecompare to other system this SPROCKET SIDE STAND RETRIEVE SYSTEM will be the life saver
  11. 11. COST ANALYSIS MATERIAL COSTSPROCKET 2 NOS 300*2= 600RSLARGER SPROCKET 1NOS 800RSWHEEL CHAIN 500RSSIDE STAND WITH 450RSBOLT&SPRINGMSRODS(FRAME,LIFTING&PUSH 1200RSING LEVER)PEDAL 200RS TOTAL 3800RS

×