How To Make A Duct Tape RosePresentation Transcript
How to Make a Duct Tape Rose!! By: Darian Ward
What You’ll Need:
Time: about 10 minutes
Some floral wire: found at almost any craft store
Start by ripping a piece of duct tape off the roll that’s about 2inx2in.
Fold the top right corner, but make sure you leave a little bit of sticky on the left side.
Then fold the left corner in the same way, making a triangle with a bit of sticky left on the bottom.
Wrap the side of your petal around the tip of your floral wire.
Repeat steps 2 and 3.
Continue this until you have a good amout of petals. You can decide when you think you have enough. Though, it should look something like this:
Now, take the color duct tape you want yo be your stem color. Rip about one cercumference around the roll (or one & a half depending on how long your wire is.) Then, start wraping your tape around the top of your stem, working your way down. If you have a bit extra, don't throw it way just yet. You might need it for this next step.
With your extra stem tape, wrap it around the bottom of your rose. This will help your rose to stay on better and it will look pretty.
Well, that's it. Have a ball! Or a duct tape rose! ;D
"Duct Tape Rose." Instructables - Make, How To, and DIY . 15 May 2009 <http://www.instructables.com/id/Duct-Tape-Rose/>.
"035 - 02.04.09 on Flickr - Photo Sharing!." Welcome to Flickr - Photo Sharing . 15 May 2009 <http://www.flickr.com/photos/monklin/3262729362/>.
"Swimmer Ice Cream Clock on Flickr - Photo Sharing!." Welcome to Flickr - Photo Sharing . 15 May 2009 <http://www.flickr.com/photos/iheartcramcream/759193853/>.
"Day306 on Flickr - Photo Sharing!." Welcome to Flickr - Photo Sharing . 15 May 2009 <http://www.flickr.com/photos/sarah70/2497706180/>.