Ccna 4 chapter 2 v4.0 answers 2011

1,178 views
1,113 views

Published on

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
1,178
On SlideShare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
51
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Ccna 4 chapter 2 v4.0 answers 2011

  1. 1. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.infoCCNA 4 Chapter 2 V4.0 Answers1.Refer to the exhibit. Router R1, the DCE device, has just been configured for PPPencapsulation with authentication. What series of commands will allow anotherrouter, the DTE device, to communicate over its serial 0/0/0 interface to router R1?Router(config)# hostname R3R3(config)# username R1 password CiscoR3(config)# interface Serial 0/0/0R3(config-if)# encapsulation pppR3(config-if)# ip address 172.16.3.3 255.255.255.0R3(config-if)# ppp authentication chapRouter(config)# hostname R3R3(config)# username R3 password CiscoR3(config)# interface Serial 0/0/0R3(config-if)# encapsulation pppR3(config-if)# ip address 172.16.3.3 255.255.255.0R3(config-if)# ppp authentication chapRouter (config)# username Router password CiscoRouter (config)# interface Serial 0/0/0Router (config-if)# clockrate 64000Router (config-if)# encapsulation pppRouter (config-if)# ip address 172.16.3.1 255.255.255.0Router config-if)# ppp authentication chapRouter (config)# username R1 password CiscoRouter config)# interface Serial 0/0/0Router (config-if)# clockrate 64000Router config-if)# encapsulation pppRouter (config-if)# ip address 172.16.3.1 255.255.255.0Router (config-if)# ppp authentication chap2. Which serial communications DTE/DCE interface standard is used to providehigh-speed connectivity of up to 52 Mbps between LANs and is found on many high-end Cisco routers?
  2. 2. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.infoEIA/TIA 232 (RS-232)EIA/TIA 422 (RS-422)EIA/TIA 423 (RS-423)EIA/TIA-612/613 (HSSI)ITU V.353. Which three statements are true regarding LCP? (Choose three.)It is responsible for negotiating link establishment.It negotiates options for Layer 3 protocols running over PPP.It uses MD5 encryption while negotiating link establishment parameters.It terminates the link upon user request or the expiration of an inactivity timer.It can test the link to determine if link quality is sufficient to bring up the link.It monitors the link for congestion and dynamically adjusts the acceptable window size.4.Refer to the exhibit. On the basis of the show interface Serial0/0 output, how manyNCP sessions have been established?onetwothreefour5. Which two statements are true about time-division multiplexing (TDM)? (Choosetwo.)TDM relies on Layer 3 protocols to operate.Multiple channels can transmit over a single link.Original data streams must be reconstructed at the destination.TDM methods vary depending on the Layer 2 protocol that is used.It allows information from multiple channels to be allocated bandwidth on multiplewires.6. Which authentication protocol can be spoofed to allow playback attacks?MD5
  3. 3. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.infoCHAPPAPNCP7.Refer to the exhibit. What can be concluded about the function of the Serial 0/0/0interface on the router after the commands are entered?All username and password information that is sent will be encrypted.All authentication on the serial link will be accomplished using a two-way handshake.The Predictor algorithm will be used to compress all packets that are sent and received onthe serial link.The serial link will be closed if the number of received packets at the destination nodefalls below 90 percent of the packets that are sent.8. Which three statements are correct about HDLC encapsulation? (Choose three.)HDLC does not support CDP.HDLC and PPP are compatible.HDLC supports PAP and CHAP authentication.HDLC implementation in Cisco routers is proprietary.HDLC is the default serial interface encapsulation on Cisco routers.HDLC uses frame delimiters to mark the beginnings and ends of frames.9. What function do Network Control Protocols provide for a PPP connection?to supply error detectionto establish and terminate data linksto provide authentication capabilities to PPPto manage network congestion and to allow quality testing of the linkto allow multiple Layer 3 protocols to operate over the same physical link10. What advantage does PPP have over HDLC for serial communications?It can communicate more efficiently with other Cisco devicesIt is less complex to configureIt has less Layer 2 overheadIt supports authentication11.Refer to the exhibit. What statement is true regarding the output shown?LCP is in the process of negotiating a link.LCP and NCP are waiting for CHAP authentication to complete.
  4. 4. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.infoLCP negotiation has been successful, but NCP negotiation is in progress.Data is able to flow across this link.12.Refer to the exhibit. What statement is true regarding the output shown?NCP has successfully negotiated.The PAP passwords did not match, so the routers are trying CHAP authentication.One router has suggested PAP authentication, and the other has accepted authenticationbut suggested CHAP authentication.One router can only use PAP authentication while the other router can only use CHAP, sothe connection has been rejected.13. Which three statements correctly describe PPP authentication? (Choose three.)PAP sends passwords in clear text.PAP uses a 3-way handshake to establish a link.PAP provides protection from repeated trial-and-error attacks.CHAP uses a 2-way handshake to establish a link.CHAP uses a challenge/response that is based on the MD5 hash algorithm.CHAP uses repeated challenges for verification.14.Refer to the exhibit. While troubleshooting a serial interface, a technician enters thecommand show interface serial 0/0/0 . If the interface is in DCE mode, what twoproblems are likely to cause the indicated problem? (Choose two.)The remote CSU or DSU has failed.The router is not sensing a CD signal.A timing problem has occurred on the cable.The line is not physically connected to the CSU/DSU.The router configuration contains the shutdown interface configuration command.
  5. 5. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.info15. Why are serial connections preferred over parallel connections for longtransmission lengths?Parallel connections do not support error checking.Parallel connections are subject to excessive attenuation.Parallel connections are subject to clock skew and to crosstalk between wires.Parallel connections transmit over only two wires and therefore transmit data moreslowly.16.Refer to the exhibit. Which two statements are true regarding the output shown?(Choose two.)The router has agreed on IP parameters.The router has negotiated LCP successfully.The router is negotiating IP compression options.The router is requesting an IP address from its peer.The router has accepted IP but not the suggested IP options.17. What does the demarcation point represent in data communication physicalcircuits?DTE/DCE interface on the device connecting to the Internetlocation of the firewall or routerphysical point at which the public network ends and the private customer network beginstag assigned to the physical block where a cross-connect occurs18.
  6. 6. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.infoRefer to the exhibit. Which statement is true about PPP operation?Layer 2 is down.LCP, IPCP, and CDPCP negotiations are in progress.Only the link-establishment phase completed successfully.Both the link-establishment and network-layer phase completed successfully.19. Which two options can LCP negotiate? (Choose two.)link qualityauthenticationdynamic flow controlcompression and network layer address for IPconnection-oriented or connectionless communication methods20. Which PPP configuration option can be used to establish load balancing over theinterfaces of a router?callbackmultilinkcompressionerror detection21.
  7. 7. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.infoRefer to the exhibit. Router R1 is not able to communicate with a neighbor routerthat is directly connected to serial 0/0/0. What is the reason for this?Interface Serial0/0/0 resets very frequently.PPP LQM has shutdown the serial interface.The serial interface has no input or output queues available.The serial interface is not configured for a Layer 2 protocol.The interface has been administratively shutdown with the shutdown command.Taged:CCNA 2 Final answers,ccna 4 chapter 2,answers cisco access the wan chapter 2,CCNA 4Chapter 2 V4 0 Answers,ccna exploration 4 chapter examRelated Posts • CCNA 4 Final Exam V4.0 Answers • CCNA 4 Chapter 8 V4.0 Answers • CCNA 4 Chapter 7 V4.0 Answers • CCNA 4 Chapter 6 V4.0 Answers • CCNA 4 Chapter 5 V4.0 Answers • CCNA 4 Chapter 4 V4.0 Answers • CCNA 4 Chapter 3 V4.0 Answers • CCNA 4 Chapter 1 V4.0 Answers • CCNA 3 Chapter 2 V4.0 Answers
  8. 8. www.ccnafinal.net www.ccnafinalexam.com www.ccnaanswers.org www.ccna4u.net www.ccna4u.org www.ccna4u.info • CCNA 4 Final Exam Answers (A) • CCNA 4 Final Exam Answers (C) • CCNA 4 Final Exam Answers (D) • CCNA 4 Final answers (100% Guaranteed – Updated Dec 2010) • CCNA 4 Final exam December 2010 • CCNA 4 Final Exam Questions and Answers 2010Tags: CCNA 4, CCNA 4 Final, CCNA 4 Final Exam, CCNA 4 Final Exam Answers,ccna 4 final exam answers 2010, ccna 4 final exam answers 2011, CCNA 4 Final ExamQuestions and Answers 2010, ccna final exam answers 4.0, CCNA4 Final, ccna4 finalexamCCNA 4 Final exam December 2010 →One Response to CCNA 4 Final Exam Questions and Answers 2010

×