Your SlideShare is downloading. ×
  • Like
Why the turn signal quit working
Upcoming SlideShare
Loading in...5
×

Thanks for flagging this SlideShare!

Oops! An error has occurred.

×

Now you can save presentations on your phone or tablet

Available for both IPhone and Android

Text the download link to your phone

Standard text messaging rates apply

Why the turn signal quit working

  • 27 views
Published

 

Published in Automotive
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Be the first to comment
    Be the first to like this
No Downloads

Views

Total Views
27
On SlideShare
0
From Embeds
0
Number of Embeds
0

Actions

Shares
Downloads
0
Comments
0
Likes
0

Embeds 0

No embeds

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
    No notes for slide

Transcript

  • 1. Why the turn signal quit workingTo switches, lights dont light. May be the power supply, the following flash appliance to turn theswitch wire breaking out of place, or flash KESS V2 OBD2 Manager Tuning Kit relay and theswitch is faulty.Check the steps:(1) check the flash relay if there is a electric wire head.(2) if there is electricity, and then use a screwdriver will flash relay two column short answer,make it out, if then turned to the light, that is flashing relay is defective. Open the mpps v13.02flash relay cover, check whether the coil, resistance is in good condition, if the resistance heating,and contact cannot be closed, can press the activity contact, then if turned to the light, that flashrelay is defective. If the contact gap is too big, should be adjusted properly. If press activities ofcontact, contact closure when the turn signal is not bright, can be used with a screwdriver willcontact short sub, if at this point the light shows a contact oxidation.(3) use a screwdriver will flash relay two pick column short it if the lights AD900 are not bright,could be turned to the switch is faulty. Inspection, respectively on wire to switch is available witha screwdriver and a line left and right column. If the light is said to switch is faulty, should removethe repair or replacement.V124 Renault CAN Clip Diagnostic Interface Newest version B- Insatall videohttp://www.youtube.com/watch?v=eV2Alkkf3jA&feature=youtu.be