http://www.careucar.com/wholesale/pin-code-reader-for-chrysler.html This is pin code reader for Chrysler, its function is reading out Chrysler (TYPE2) vehicle pin code. Read data from Immobilizer controller and show the pin code on the screen of the device directly. We supply this pin code reader with unlimited technical support and one year warranty.

1. How to use Pin code reader for Chrysler?
As there is only one button on Pin code reader for Chrysler, some customers do not
have clue about how to use it to read Pin codes. Therefore, Careucar technicians
have made a tutorial on how to get pin code with the tool, hope it helps.
Method 1
1. Remove the IMMO box from the Chrysler vehicle that you are going to read Pin
code from. The box is located on the Ignition lock. Below is the IMMO box:

2. 2. Open the box, desolder the two pins of coil connection on the PCB (as shown in the
picture below) and remove them off.
3. Find a chip named EEPROM “24LC02B” on the board. It is nearby one of the coil
connections removed just now.

3. 4. Clean every pin of the 24LC02B chip and connect the clip to the microchip, black
point to pin1 of the chip.
5. Press “ Read Pin “ button on the Pin code reader for Chrysler, and you will then

4. see its Pin code on the screen.
Method 2
Here is another way to use the Chrysler Pin code reader. The tool comes with a 4
wires cable. By using the cable, you can read the pin code without removing the
connections from the IMMO box.
1. Remove the IMMO box from the Chrysler vehicle that you are going to read Pin
code from. The box is located on the Ignition lock. Below is the IMMO box:
2. Connect the white wire to point1 , black wire to point2 , blue wire to point3
red wire to point4.
3. Press “Read Pin” button on the unit, The screen will then show the Chrysler Pin
code.