2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe

2007 ENGIN...
2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe

Fig. 2: Id...
2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe

Fig. 3: Di...
2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe

Fig. 4: Id...
2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe

Standard :...
2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe

REPLACEMEN...
2007 Hyundai Santa Fe Limited
2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe




2.7L:...
Upcoming SlideShare
Loading in...5
×

2.7 l ignition

1,050

Published on

Published in: Business, Technology
0 Comments
2 Likes
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total Views
1,050
On Slideshare
0
From Embeds
0
Number of Embeds
0
Actions
Shares
0
Downloads
24
Comments
0
Likes
2
Embeds 0
No embeds

No notes for slide

2.7 l ignition

  1. 1. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe IGNITION SYSTEM DESCRIPTION Ignition timing is controlled by the electronic control ignition timing system. The standard reference ignition timing data for the engine operating conditions are preprogrammed in the memory of the ECM (Engine Control Module). The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM. The ignition coil is activated, and timing is controlled. ON-VEHICLE INSPECTION SPARK TEST 1. Remove the ignition coil connector (A). Fig. 1: Locating Ignition Coil Connector Courtesy of HYUNDAI MOTOR CO. NOTE: 2. 3. 4. 5. Disconnect the ignition coil connector while pulling up the connector lock. Remove the ignition coil. Using a spark plug socket, remove the spark plug. Install the spark plug to the ignition coil. Ground the spark plug to the engine. Microsoft Saturday, September 26, 2009 12:08:41 PM 12:08:45 Page 1 © 2005 Mitchell Repair Information Company, LLC.
  2. 2. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe Fig. 2: Identifying Ground Spark Plug To Engine Courtesy of HYUNDAI MOTOR CO. 6. Check is spark occurs while engine is being cranked. NOTE: 7. 8. 9. 10. To prevent fuel being injected from injectors while the engine is being cranked, remove the fuel pump (A) relay from the fuse box. Crank the engine for no more than 5 ~ 10 seconds. Inspect all the spark plugs. Using a spark plug socket, install the spark plug. Install the ignition coil. Reconnect the ignition coil connector. Microsoft Saturday, September 26, 2009 12:08:41 PM Page 2 © 2005 Mitchell Repair Information Company, LLC.
  3. 3. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe Fig. 3: Diagnostic Flow Chart Courtesy of HYUNDAI MOTOR CO. INSPECT SPARK PLUG 1. Inspect the electrodes (A) and ceramic insulator (B). Microsoft Saturday, September 26, 2009 12:08:41 PM Page 3 © 2005 Mitchell Repair Information Company, LLC.
  4. 4. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe Fig. 4: Identifying Electrodes And Ceramic Insulator Courtesy of HYUNDAI MOTOR CO. INSPECTION OF ELECTRODES INSPECTION OF ELECTRODES Condition Dark deposits Description   Fuel mixture too rich Low air intake White deposits    Fuel mixture too lean Advanced ignition timing Insufficient plug tightening torque 2. Check the electrode gap (A). Standard : 1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.) Fig. 5: Checking Electrode Gap Courtesy of HYUNDAI MOTOR CO. INSPECT IGNITION COIL 1. Measure the primary coil resistance between terminals (+) and (-). Microsoft Saturday, September 26, 2009 12:08:41 PM Page 4 © 2005 Mitchell Repair Information Company, LLC.
  5. 5. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe Standard : 00715 ± 0.015ohms Fig. 6: Measuring Primary Coil Resistance Between Terminals (+) And (-) Courtesy of HYUNDAI MOTOR CO. NOTE: Measure the resistance between the terminals No.1 and No.3. REMOVAL IGNITION COIL 1. Remove the engine cover. 2. Remove the ignition coil connector (A). Fig. 7: Identifying Ignition Coil Connector Courtesy of HYUNDAI MOTOR CO. 3. Remove the ignition coil. 4. Installation is the reverse of removal. Microsoft Saturday, September 26, 2009 12:08:41 PM Page 5 © 2005 Mitchell Repair Information Company, LLC.
  6. 6. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe REPLACEMENT SPARK PLUG 1. Remove the ignition coil connector (A). Fig. 8: Identifying Ignition Coil Connector Courtesy of HYUNDAI MOTOR CO. 2. Remove the ignition coil. 3. Using a spark plug socket, remove the spark plug. CAUTION: Be careful that no contaminates enter through the spark plug holes.. 4. When replacing the spark plug, always use the long reach type spark plug. Do not use a short reach type. 1. Color Marking (Tip).  [2.7L] Unleaded : Yellow Marking Leaded : Green Marking  [Others] Marking Color is different or does not exist 2. Length (Tip-Tip / PT Length). Microsoft Saturday, September 26, 2009 12:08:41 PM Page 6 © 2005 Mitchell Repair Information Company, LLC.
  7. 7. 2007 Hyundai Santa Fe Limited 2007 ENGINE Ignition System (Engine Electrical System (G6EA-GSL 2.7)) - Santa Fe   2.7L: 83.2mm/ 26.5mm [Others] The length is different from the specification above. 3. Part ID.  [2-7L] Unleaded : ILFR5B11 Leaded : LFR5A Microsoft Saturday, September 26, 2009 12:08:41 PM Page 7 © 2005 Mitchell Repair Information Company, LLC.

×