STEP 1 - Putting The Carbon Paper and Figure/Design on Plywood
To make it, first of all, you should take the plywood and put carbon paper on it, but you need to be carefull about that the carbon paper shouldn’t movie while you are drawing the figure or design on plywood, so you can use a friction tape to solve this problem… (As you seen on the photo…)
As you seen on photo, you should put the figure /design on carbon paper by using a friction tape to keep stable the paper, before drawing the figure on plywood…You can draw geometrical shapes, flowers, asymmetrical shapes or what you want to draw…
STEP 2 – Drawing The Figure/Design on The Plywood And then, you should follow the figure’s line to transfer same apperience on plywood by using carbon paper and pencil…Just take a view that photo …!
You can draw what you want to draw on plywood… it depends on your creativity The figure which below is for a napkin holder…As you seen, the same figure has transferred on plywood, so it s ready to be cut by fret saw…!
STEP 3 – Cutting the Plywood by Using Fretsaw To cut the plywood firstly, you should put the blade of it tightly…
And then, you can begin to cut the plywood by following the line’s of design… However, you should be carefull while you are cutting it, because it is so thin and you can break it easily..!
What is the link between fretworks with our comenius project???
These all fretworks are to teach and to control our pupil’s “eye-hand coordinations” and “to impress their insight materials ” …. The idea that the link of fretworks and our project them is; if the pupils can learn the people who use what kind of wood materials in their daily life and if we teach wood cutting techniques at their education process to pupils, by this way they can use these techniques at their working life…If they produce these wood productions which are table napkin, bread box, candlestick, key holder etc…they can sell them who wants to buy…They can sell these wood productions and earn money, money and money