• Like
09 canon pg cl ink counter reset flyer
Upcoming SlideShare
Loading in...5
×

Thanks for flagging this SlideShare!

Oops! An error has occurred.

09 canon pg cl ink counter reset flyer

  • 111 views
Published

 

  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Be the first to comment
    Be the first to like this
No Downloads

Views

Total Views
111
On SlideShare
0
From Embeds
0
Number of Embeds
0

Actions

Shares
Downloads
0
Comments
0
Likes
0

Embeds 0

No embeds

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
    No notes for slide

Transcript

  • 1. Please follow these instructions when installing your cartridge. Many Canon PG and CL inkjet cartridges have nagging “Out-Of-Ink/Low-Ink Level” pop-up messages when using remanufactured inkjet cartridges. To prevent these messages from recurring, the following steps should be performed only once after each cartridge installation for either the black or color cartridge or when and if a cartridge is removed or replaced. Step 1 > After installing the cartridge into the printer this screen prompt will appear Select “OK” The same prompt is given when installing a new OEM cartridge; printers do not automatically print an alignment page. Step 2 > When the first print job is queued or sent to the printer this screen prompt will appear with a print status prompt in the lower right side of the screen. DO NOT SELECT, CLICK OR PRESS ENTER IN THE SCREEN PROMPTS All-in-Ones > Press and Hold the Stop/Reset Button on the printer for 5 second or until the screen prompt disappears Printers > Press and Hold the Resume/Cancel disappears. If a cartridge is removed from the printer for refilling before it was empty the cartridge will print until the drop count had been reached. When the cartridge drop count is reached the software prompts will appear. The print status prompt in the lower right side of the screen will appear with every print job but no further action is needed to print. Cartridges will always be displayed as Empty. Software prompts on newer Canon All-in-Ones/Printers may vary. Stop/Reset Button (Canon MX-310) For additional information please visit www.sme-us.com Disclaimer: SME is not affiliated with the Canon Corporation or any other OEM. Any Canon trademarks or logos belong to the Canon Corporation. SME assumes zero responsibility for the accuracy or consequences if any suggestions or steps listed above are acted upon. The information above is to be used at your own risk. Use of the screen shots or photos above came from printing on our lab printers. SME reserves all rights to take legal action if used without permission.