Basics of elec.
Upcoming SlideShare
Loading in...5
×
 

Like this? Share it with your network

Share

Basics of elec.

on

  • 355 views

 

Statistics

Views

Total Views
355
Views on SlideShare
355
Embed Views
0

Actions

Likes
0
Downloads
25
Comments
0

0 Embeds 0

No embeds

Accessibility

Categories

Upload Details

Uploaded via as Microsoft PowerPoint

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

Basics of elec. Presentation Transcript

  • 1. BASICS OF ELECTRONICS
  • 2. We will be discussing….. • Resistor • Capacitor • Diode • Transister
  • 3. RESISTORS • Resistors are used to limit current or divide voltage and in some cases, generate heat. • Used for driving circuit which requires low current and voltage than available. • A two terminal non-polarised component.
  • 4. • Unit of resistance is ohm. • Notation for resistance O- for ohm K- for kilo ohm M- for mega ohm Contd…
  • 5. Physical appearance
  • 6. Color code table
  • 7. Practical Use…. • To reduce the current flowing in circuit, use resistance in parallel.
  • 8. • To reduce the voltage for any circuit, use resistance in series.
  • 9. CAPACITORS • A two terminal electronic component which stores energy in form of charge. • capacitance is a measure of a capacitor's ability to store charge. • A large capacitance means that more charge can be stored. • Capacitance is measured in Farads(F) but prefixes like µF and pF for smaller values.
  • 10. Types of capacitors • Polarized which have specified positive and negative terminals. • Non-polarized no defined polarity for terminals.
  • 11. Practical use • Used for making timer circuits, when used with resistance. • Used in clipper, clamper circuit. • Used for providing instantaneous large power as in flashlight of cameras. • Used in DC filter circuits.
  • 12. DIODES • A two-terminal electronic component that conducts electric current in only one direction.
  • 13. The direction of arrow shows the only possible direction of current.
  • 14. Types of diodes • LED i.e Light Emitting Diodes These diodes emit light when provided with power supply.
  • 15. • Photodiode These diode generates currents when exposed to light.
  • 16. Practical use • Used for making gates • Used for making rectifiers • Used as a switch • LED as indicators • Photodiodes as light detector
  • 17. TRANSISTOR • A transistor is a semiconductor device commonly used to amplify or switch electronic signals. • Device with three terminals where one terminal can be use to control the flow of current through the other two terminals.
  • 18. Contd…. • The three terminals are Emitter, Base and Collector
  • 19. • Transistor are of two types: 1-> n-p-n A straight switch 2-> p-n-p A inverted switch
  • 20. n-p-n as straight switch • When base of n-p-n is connected with logic high voltage then it short circuit emitter and collector (SWITCH ON). • When base of n-p-n is connected with logic low voltage then it open circuit both emitter and collector (SWITCH OFF).
  • 21. p-n-p as inverted switch • When base of p-n-p is connected with logic high voltage then it open circuit emitter and collector (SWITCH OFF). • When base of p-n-p is connected with logic low voltage then it short circuit both emitter and collector (SWITCH ON).
  • 22. Practically used… • As a switch • As an amplifier • For realizing logic gates
  • 23. Thank You