Your SlideShare is downloading. ×
Boot Process Of Ip Phone
Upcoming SlideShare
Loading in...5
×

Thanks for flagging this SlideShare!

Oops! An error has occurred.

×
Saving this for later? Get the SlideShare app to save on your phone or tablet. Read anywhere, anytime – even offline.
Text the download link to your phone
Standard text messaging rates apply

Boot Process Of Ip Phone

664

Published on

0 Comments
1 Like
Statistics
Notes
  • Be the first to comment

No Downloads
Views
Total Views
664
On Slideshare
0
From Embeds
0
Number of Embeds
1
Actions
Shares
0
Downloads
0
Comments
0
Likes
1
Embeds 0
No embeds

Report content
Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
No notes for slide

Transcript

  • 1. Boot Process of IP PhoneThis figure provides an overview of the startup process for a Cisco IP Phone if you are using a Cisco Catalyst switch that is capableof providing Cisco prestandard Power over Ethernet (PoE). 1. Obtain power from the switch: If you are using a Cisco switch that is capable of providing Cisco inline power, the switch will send a Fast Link Pulse (FLP) signal. The switch uses the FLP to determine if the attached device is an unpowered Cisco IP Phone. In the unpowered state, a Cisco IP Phone loops back the FLP, signaling the switch to send -48 V DC power down the line. 2. Load the stored phone image: The Cisco IP Phone has nonvolatile Flash memory in which it stores firmware images and user-defined preferences. At startup, the phone runs a bootstrap loader that loads a phone image stored in Flash memory. Using this image, the phone initializes its software and hardware. 3. Configure VLAN: After the IP Phone receives power and boots up, the switch sends a Cisco Discovery Protocol packet to the IP Phone. This Cisco Discovery Protocol packet provides the IP Phone with voice VLAN information, if that feature has been configured. 4. Obtain IP address and TFTP server address: Next, the IP Phone broadcasts a request to a DHCP server. The DHCP server responds to the IP Phone with a minimum of an IP address, a subnet mask, and the IP address of the Cisco TFTP 5. Contact TFTP server for configuration: The IP Phone then contacts the Cisco TFTP server. The TFTP server has configuration files (.cnf file format or .cnf.xml) for telephony devices, which define parameters for connecting to Cisco CallManager. The TFTP server sends the configuration information for that IP Phone, which contains an ordered list of up to three Cisco CallManagers. In general, any time you make a change in Cisco CallManager that requires a phone (device) to be reset, a change has been made to the configuration file of that phone. If a phone has an XML-compatible load, it requests an XMLDefault.cnf.xml format configuration file; otherwise, it requests a .cnf file. If you have enabled auto-registration in Cisco CallManager, the phones access a default configuration file (sepdefault.cnf.xml) from the TFTP server. If you have manually entered the phones into the Cisco CallManager database, the phone accesses a .cnf.xml file that corresponds to its device name. The .cnf.xml file also contains the information that tells the phone which image load that it should be running. If this image load differs from the one that is currently loaded on the phone, the phone contacts the TFTP server to request the new image file, which is stored as a .bin file. 6. Register with Cisco CallManager: After obtaining the file from the TFTP server, the phone attempts to make a TCP connection to the highest-priority Cisco CallManager on the list.

×