Ceramic Roofing System
                                                      Step by Step




 1. Pressure wash to achieve...
Ceramic Roofing System
                                                       Step by Step




7. Inspect surface area aga...
Upcoming SlideShare
Loading in …5
×

Astec Step by Step Application Overview

758 views
696 views

Published on

Astec Step by Step Application Overview

0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
758
On SlideShare
0
From Embeds
0
Number of Embeds
6
Actions
Shares
0
Downloads
0
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Astec Step by Step Application Overview

  1. 1. Ceramic Roofing System Step by Step 1. Pressure wash to achieve a clean surface free of dirt, 2. Fasteners, screws and fastening devices are first rust, corrosion, residues, and any other contaminants. tightened and/or replaced. 3. Remove ALL scaling rust by scraping or mechanical 4. Caulk all exposed cracks and seams with Astec wire brush. Follow with a TWO coat application of B-16-71 #2001 Acrylic Latex Caulk. Optionally, in gaps and @ 300 sf/gal per coat. Prime ALL corroded surfaces. cracks 1/8” or less in width, brush in Astec WPM #9. 5. Waterproof ALL Horizontal Seams with 4” wide polyester 6. Waterproof Vertical Seams with 2” wide Polyester Cloth cloth embedded into a 8” wide wet coat of WPM #9 B&R. embedded in a 4” wide wet coat of WPM #9 B&R. Apply a Apply a second coat of WPM #9 B&R overlapping 2” on second coat of WPM #9 B&R overlapping 1” on each side each side at an average rate of 82 sf/gal per coat. at an average rate of 82 sf/gal. Insulating Coatings Corporation - 956 South Highway 41 , Inverness, FL 34450 1 (800) 345-5306 - Fax : (352) 344-8370 - iccsouth@icc-astec.com
  2. 2. Ceramic Roofing System Step by Step 7. Inspect surface area again to be sure it is clean, dry and free of defects. The WPM #9 membrane must be free of all moisture, dirt, dust, and debris before applying the ceramic #900 finish coat. 8. Apply Astec #900 over the WPM #9 membrane covering joints, flashings, and repair areas at a rate of 74 sf/gal. 9. Apply first coat Astec #900 Ceramic over the entire roof 10. Apply second coat of Astec #900 ceramic over the surface at an average coverage rate of 148 sf/gal to lower entire roof surface at an average rate of 148 sf/gal, substrate surface temperature, improve the rate of curing resulting in a final covering of no less than twelve (12) mils and the quality of the finished appearance. DFT (equal to a combined minimum coverage rate of 74 sf/gal). Over seams and repair areas the final specification requirements will be an average of 45 mil DFT. OPTIONAL 11. Apply #2541 Skylight Sealer on Skylights at the rate of 225-335 sf/gal Insulating Coatings Corporation - 956 South Highway 41 , Inverness, FL 34450 2 (800) 345-5306 - Fax : (352) 344-8370 - iccsouth@icc-astec.com

×