Mecatronica diaz

572 views

Published on

Published in: Education
0 Comments
0 Likes
Statistics
Notes
  • Be the first to comment

  • Be the first to like this

No Downloads
Views
Total views
572
On SlideShare
0
From Embeds
0
Number of Embeds
4
Actions
Shares
0
Downloads
6
Comments
0
Likes
0
Embeds 0
No embeds

No notes for slide

Mecatronica diaz

  1. 1. Lighthouse Electric. <ul><li>Brenda Gpe. De la Rosa Padrón. </li></ul><ul><li>Alejandra Díaz Vaca </li></ul><ul><li>2amt </li></ul>
  2. 2. Materials: <ul><li>Switch Fuse Lights Cable proto board Battery Relay Proto board </li></ul>
  3. 3. Procedure: <ul><li>First to get all the materials to do the project. After having all the materials you read the following diagram. Place two pockets pretending to be lights, each bulb has its negative and positive .... With the proto board to cable these lights are connected to relay a positive and the other pole of outbreaks is connected in the negative. </li></ul>
  4. 4. Legend: Cable Positive Negative Cable Ground
  5. 5. <ul><li>After the negative pole of the switch is connected to the proto negative and positive side is connected to the relay (the relay is to generate more energy than is being used) The battery or power must be 12 volts, the negative terminal of the battery goes to the negative side of the proto, and the positive side is connected to a fuse (the fuse should generate 30 AMP.) And the fuse is another positive bridge relay. </li></ul>
  6. 6. Amp that has to apply to operate independently: <ul><li>86 to the battery cable or a fuse box that always has power. 85 to switch and switch to land on a screw in the body. 30 to the battery with a fuse as close to the battery. 87 to the headlights. </li></ul>
  7. 7. thank you!!

×