Our range of flue, chimney and exhaust systems range from 100mm to 1200mm diameter and have been specifically developed to provide an optimum solution for a varying range of commercial and industrial applications.
Common systems include multi-functional fire rated or gas condensing exhausts; flues for use with naturally aspirated gas fired appliances fitted with draught diverters; twin wall insulated, multi-fuel chimney systems; twin wall systems for use with solid fuels; single wall flue systems for gas and oil products and gas and oil venting systems.
All solutions are designed, tested and manufactured to meet the highest standards and maximum performance is ensured by prior measuring using our iCalc software. Our systems conform to the most up to date legislation requirements and our installation teams are experienced personnel, fully aware of all necessary statutory requirements and modern standards.
Flues & Chimney Case Study for Oakham Primary School
1. Project Profile
Oakham Primary School, Dudley, West Midlands
Consultant
■ BSD
Client
■ Lord Combustion Limited
Front Entrance
Sector
■ Education
Products
■ DW Flue System
Twin wall flue Header System with 30 incline
Equipment Airtherm have recently designed, supplied and installed a complete twin wall
stainless steel flue system serving each MHS Adinox ADI LT 200 modulating boiler
at Oakham Primary School in Dudley in the West Midlands.
■ MHS ADI LT
The existing cast iron boilers were removed by the contractor during the School
summer shut-down, working on a tight program the MHS high efficiency boilers
were installed followed by the installation of our flue system. All of the plant was
commissioned in time for the return of the pupils to enter a new begging.
Application
The flue system installed was designed to completely evacuate the products
■ High Efficiency Condensing combustion taking into account for the over-pressure from each appliance. Each
primary flue incorporated a volume control damper and draft regulator in the event
of unstable operation. The complete system had a 30 fall back to the appliance to
allow condense to vacate and drain from the flue.
Airtherm Engineering Ltd only uses branded products which are synonymous with
the highest quality - and it is this reputation that enables specifiers and contractors
to use our versatile product range with total confidence
We can provide technical solutions for the specialist areas of high temperature
exhaust systems, serving generators & combined heat and powder units, fan
MHS ADI LT Boilers assisted, flue dilution and atmospheric applications.
0844 809 2509 | airtherm.co.uk | info@airtherm.co.uk
2. Product Solution
• Boilers: MHS
• Model: ADI LT 200
• Application: Chimney / Flue system
• Operating mode: Wet
• Pressure: Negative / positive pressure
• Working pressure: 200 Pa (product will operate 1000pa max)
• Inner wall: 316L1.4404/1.457 thickness 0,6 mm
• Outer wall: 304/ 1.4301 thickness 0,5
• Insulation: 30mm thick Rockwool insulation
• Sealant : Tri-lip 'o' type silicone ring
Airtherm Masterflue • Fuel type: Gas
• Other Application Dinak Flues can be used:
• Condensing boilers
• Atmospheric gas-fired boilers
• Gas blown boilers
Primary Flues
• Industrial ovens, large-scale establishments
Contact Details: • Wood-fired stoves
Airtherm Engineering Ltd
Ventilation House
Pedmore
Stoubridge
West Midlands
DY9 0DS
Tel: 0844 8092509
Fax: 01562 887312
0844 809 2509 | airtherm.co.uk | info@airtherm.co.uk