• Share
  • Email
  • Embed
  • Like
  • Save
  • Private Content
Making Art With Rock Carving
 

Making Art With Rock Carving

on

  • 26 views

Visit http://www.cloaklinks.com/recommends/onlineentertainment for more info

Visit http://www.cloaklinks.com/recommends/onlineentertainment for more info

Statistics

Views

Total Views
26
Views on SlideShare
25
Embed Views
1

Actions

Likes
0
Downloads
0
Comments
0

1 Embed 1

http://www.slideee.com 1

Accessibility

Upload Details

Uploaded via as Microsoft PowerPoint

Usage Rights

© All Rights Reserved

Report content

Flagged as inappropriate Flag as inappropriate
Flag as inappropriate

Select your reason for flagging this presentation as inappropriate.

Cancel
  • Full Name Full Name Comment goes here.
    Are you sure you want to
    Your message goes here
    Processing…
Post Comment
Edit your comment

    Making Art With Rock Carving Making Art With Rock Carving Presentation Transcript

    • Making Art With Rock Carving
    • You have the love for art and you want to create your masterpiece out of the single rock that you have seen ashore. You want to chisel it and transform it to the subject of your imagination. But you do not know how to start the process except by imagining. In this case, you just happened to be at the right place that will give you tips all the way from rock carving Alberta.
    • First of all, you have to come up with a design. Something that you can manifest into a stone carving. This will depend on the creativity and the determination that you go to create your very own masterpiece. You can ether discover a stone that suggests the design or model out using the clay so to work out the details.
    • Choose a stone, that is the next step of the procedure. There are many stones that are available and suitable for the engraving or carving. You can do a research about the rock that you have seen and the right procedure to be applied on it so that you will create the very first piece.
    • And since you can no carve the rocks by your own two hands, you need the tool to be used as soon as the process already started. This involves the driller, the sandpaper, the smaller grinder, the chisel, the pitching tool, the tracing tool, and the hammer. You can borrow them from your friends too.
    • And by the way, this is going to be a dangerous job since you will be dealing with the sharp edge tools. In this case, you should keep the appropriate tools in your hands. Or you will find your hands tainted with blood as soon as you finished the work of art made through stone.
    • While you are working you have to be focused on your goal. That is, to either create an image of someone or something. Without it, then there is that ambiguous possibility that you will come up with the desired result of yours. You can do this on either the flat surface or three d.
    • And you shall always consider the importance of following the grains length in the carving process. Always remember that even the tiniest details can result to breaking off. You need to sketch your design on the rocks flat surface. And always follow the direction of the rocks grain. This should never run cross wise to avoid breaking off.
    • And always remember that each of those tools vary on their designation. They have different functions, might you add. And to make the story short, using the wrong tool is likely to destroy everything in a blink of an eye. Hence, might push you to do the process for the second time.
    • And also, you have to take consideration of polishing that rock carving Alberta. This is necessary since there will be grits that will be left after you have chiseled them all. Most likely, they could cut your skin. So to polish the surface, use the dry sandpaper or the wet silicon carbide for that.
    • http://www.cloaklinks.com/recommends/onlineenterta inment