Email
Favorite
Favorited ×
Download
Embed
Private Content
Copy and paste this code into your blog or website Copy Customize Close
We have emailed the verification/download link to "".
Login to your email and click the link to download the file directly.

To request the link at a different email address, update it here. Close
Validation messages. Success message. Fail message.

Check your bulk/spam folders if you can't find our mail.

+ Follow

Eight tips for energy conservation in the data

by Logicalis on Nov 21, 2011

77 views

Learn our top eight tips for energy conservation in the data center.

More…

Learn our top eight tips for energy conservation in the data center.

Less

Statistics

Favorites: 0
Downloads: 0
Comments: 0
Embed Views: 0
Views on SlideShare: 77
Total Views: 77

Since about half of the energy spent in a data center revolves around cooling, it’s critical to keep the cool air in! Any level of passive containment is good – hot out or cold in containment. Passive heat rejection cabinets are a great option; they can be installed new or older cabinets can be retrofitted with chimneys and rear cabinet enclosures can be added to existing environments, allowing the temperature in the room to be raised safely to between 73 and 77 degrees, well below the new 80-degree ASHRAE standard.
Too often, you see data centers in colder climates where the outside air temperature is 10 degrees in the winter, yet the refrigeration systems are working hard to cool the data center inside. Let the outside air help cool the data center whenever possible – air side economization should be intuitive in the Central and Northern hemispheres of the United States. Bringing in the cooler outdoor air is not as easy as it sounds since that air must be filtered to remove pollutants and humidity, but there are advanced systems available today – like the Kyoto autonomous air-to-air heat-exchange cooling solution in use at BendBroadband, a cable/broadband provider in central Oregon. BendBroadband’s Kyoto cooling solution – the largest installation of its kind in the U.S. – requires no water and takes advantage of cool nights to contribute as much as 85 percent of the data center’s required cooling.
Consider this surprising fact: The higher the voltage in the data center, the more electrically efficient the data center will be. Since power already enters the building at a higher voltage, running on 415 volts means less power conversion is needed. And, data centers that run on 415-volt power require smaller power cables, which means less copper, less cable and smaller cable trays. This is something that is easiest to consider before building a data center rather than as a retrofit. A retrofit is, of course, possible but would require a substantial amount of work, changing panels from the street to the UPS to the delivery mechanisms.
Using a solar panel array on a data center rooftop can dramatically offset energy costs inside the data center as well. While the savings can provide a significant return on investment, other important reasons to consider sun power include a reduced carbon footprint, a serious issue for responsible corporate stewardship and one reason the North County Transit District in San Diego built the first mass transit LEED green certified data center in the country.
Many states have programs – Blue Sky is an example – that allow companies to use 100 percent alternative or renewable energy sources like hydro and wind power. Typically, these programs can cost a few kilowatt cents per hour more but the energy savings give the data center a near zero carbon footprint and have the added bonus of helping to support the growth and expansion of alternative power programs for the next generation.
In the data center, going with white cabinets, walls, floors and ceilings helps reflect heat and bring the hot air back into the return more easily. An all-white data center is also very IT friendly – less light is needed to look inside cabinets; no more using a flashlight to screw a server into a rack! With all white cabinetry, there is very little need for additional lighting, a quick-fix during a renovation and most certainly something to consider when building a new data center.
Consider LEDs instead of standard T5 lighting for the data center. LED lighting is brighter, uses less energy, and it produces less heat so it is an all-around solid lighting solution.
To be a truly socially conscious organization, use recycled materials whenever possible. Mobach says Logicalis has created data centers with everything from recycled cork and bamboo to a LEED-certified data center using recycled blue jeans as insulation in the walls.

Eight tips for energy conservation in the data — Presentation Transcript

Eight Tips forEnergy Conservationin the Data Center
Tip #1:CoolingContainment1
Tip #2:Pre-Cooling2
Tip #3: 415 Volts3
Tip #4:Solar Panels4
Tip #5:Energy-SavingPrograms5
Tip #6:Go White6
Tip #7:LED Lighting7
Tip #8:RecycledMaterials8
Business and TechnologyWorking as Onewww.us.logicalis.com866.456.4422 www.facebook.com/Logicalis http://twitter.com/#!/logicalis www.linkedin.com/company/logicalis www.hypeorripe.com

Eight tips for energy conservation in the data

by Logicalis on Nov 21, 2011

Accessibility

Categories

Tags

Upload Details

Usage Rights

Statistics

Eight tips for energy conservation in the data — Presentation Transcript